11
OPERATION
STARTING THE ENGINE
WARNING
Keep the blade clear of everything around it as it will start
moving upon the engine starts.
(1) Press carburetor cap several times with finger until oil pipe full
of fuel.
(2) Please pull the air shutter switch to the closed position. If the
engine stay in the place that just stopped, pull the switch to
open position.
(3) The setting of throttle wire and stop lead.
As drawing, connect the throttle wire of handle with one of
engine
NOTE
Be sure that the stop lead is fixed. When the gun switch
is in the original place, please gently pull the line
(movable distance is 0.5-1.0mm), otherwise rearrange
the tight degree of gun line.
(4) Place the unit on a flat, firm place. Keep the cutting
head clear of everything around it.
(5) While holding the unit firmly, pull out the starter
rope quickly.
(6) After the engine has started, allow the engine to warm up.
Pull the throttle trigger.
STOPPING THE ENGINE
(1) As drawing, release the Throttle trigger and return it to the
original condition.
8
(4)
Place the unit on a flat, firm place. Keep the cutting head
clear of everything around it.
(5)
While holding the unit firmly, pull out the starter rope quickly.
(6)
After the engine has started, allow the engine to warm up.
Pull the throttle trigger.
■
STOPPING THE ENGINE
(1)
As drawing, release the Throttle trigger and return it to
the original condition.
(2)
Push the engine stopping switch.
NOTE
If the engine doesn
’
t stop after stopping the switch, close
the choke so that engine will stop after a while.
■
CUTTING WORK
WARNING
·
Weather conditions and altitude may affect carburetor.
·
Do not allow anyone to stay close the brush cutter while working or adjusting the carburetor.
■
HOW TO USE
(1)
Shoulder hang
As picture, hang it from left shoulder to right waist, then start the engine,
make sure that the gun switch is at idle speed, connect harness interface
with one of the machine, keep the blade parallel with ground, and arrange
the length of harness to a suitable condition.
(2)
Working methods:
A . Sway brush cutter (from right to left)
B .For generic grass, one time cutting quantity is half of the blade diameter; for strong ruderal, one time
cutting quantity is one third of the blade diameter..
C. The place of gun switch is decided by the grass.
1.
Use only as much throttle as it is needed to do the job. Excessive engine speed is unnecessary.
2.
Avoid cutting branches which is too thick for the unit, as this will damage the life of drive systems.
