background image

Govaerts Recycling NV | Kolmenstraat 1324 | B-3570 Alken | [email protected] | www.govaplast.com

2

 

150 cm

 

572 cm

 

5

25

 c

m

 

150 cm

 

572 cm

 

5

25

 c

m

Installation

The installation needs to be done on a hard and even 
surface. The equipment cannot be installed on a loose 
surface such as a sandpit, wood chips, bark mulch), unless a 
special bearing construction is installed (not standard).

Security Zone

An obstacle-free area of minimum 150 cm around the 
equipment is required.

No fall absorption surface required

The equipment’s fall height is less than 60 cm. Therefore it’s 
allowed to install it on a hard surface.

Содержание biplane

Страница 1: ...ls water absorption is less than 0 29 it will not get stained by oil grease or other products Moss and algae will not adhere easily and can easily be removed Cleaning with high pressure max 100 bar is possible but not recommended and mostly even not necessary Spray with a fan shaped jet with minimum 30 cm distance from the surface Painting or staining is useless as the material does not need extra...

Страница 2: ... even surface The equipment cannot be installed on a loose surface such as a sandpit wood chips bark mulch unless a special bearing construction is installed not standard Security Zone An obstacle free area of minimum 150 cm around the equipment is required No fall absorption surface required The equipment s fall height is less than 60 cm Therefore it s allowed to install it on a hard surface ...

Страница 3: ...om the board post play and a new steering system can be screwed Anchoring or not According to the European standard playground equipment needs to be anchored Anchoring of this specific equipment is not required if installed on a school playground with supervision In case the playground is only used by the school itself the security risk due to not anchoring the equipment is relatively small If ther...

Страница 4: ...e position of the wing is marked Place the wing supports Mount the upper part of the wing Detail of upper wing Detail of upper wing Slide the lower part of the wing under the fuselage The holes are pre drilled Use the supplied screws 8 x 80 Torx 40 Mount the wing supports with the 2 supplied screws 8 x 120 Torx 40 and the 2 yellow cover caps Finally mount the back wing ...

Отзывы: