9
SET
TING
YOUR ESPRESSO MA
CHINE
Setting the Quantity
1. While each button has a default setting for the amount of coffee it will
dispense, you can also adjust its amount to suit your needs.
This can be accomplished while the unit is in standby mode - with ALL
THREE BUTTONS in BLUE.
2. For a small/short setting, press and hold down the Short Cup Button for
as long as you want it dispense coffee (from 15 seconds but no longer
than 80 seconds) and then release it. The machine will remember this
setting when this button is used. To change the Long Cup setting simply
repeat the above instructions while holding down the Long Cup Button.
3. To return back to the default setting: Press the both, the Short and Long
Cup buttons at the same time untill they flash 3 times, the buttons will
now return to its default settings.
Setting the Temperature
1. While the unit has a default temperature setting, six more temperature
settings are available. The coffee temperature may be increased 4 levels
and decreased 2 levels.
(To change back to default setting follow #3 step from above)
2. TO DECREASE TEMPERATURE LEVEL:
Unit must be in standby mode - with ON/OFF button in RED.
Note: Default level is considered Level 3.
• To increase tem-
perature by
1
one
level, press the
Long Cup Button
for one second -
it will flash 1 time,
indicating that the
Long Cup Button
was increased
by one level,
to level 4.
• To increase tem-
perature by two
levels, press the
Long Cup Button
two times -
it will flash 2 times,
indicating that the
Long Cup Button
was increased
by two levels,
to level 5.
• To increase tem-
perature by three
levels, press the
Long Cup Button
three times -
it will flash 3 times,
indicating that the
Long Cup Button
was increased
by three levels,
to level 6.
• To increase tem-
perature by four
levels, press the
Long Cup Button
four times -
it will flash 4 times,
indicating that the
Long Cup Button
was increased by
4 levels, to level 7.
(
the maximum
)
• To decrease temperature by one
level, press the Short Cup Button for
one second - it will flash two times,
indicating that the Short Cup Button
will now dispense at level 2 heat
setting.
• To derease by two levels, press the
Short Cup Button two times -
it will now flash 1 time, indicating
that the Short Cup Button will now
dispense at level 1 heat setting.
(
the lowest
)
3. TO INCREASE TEMPERATURE LEVEL:
Unit must be in standby mode - with ON/OFF button in RED.
Note: Default level is considered Level 3.
