13
EN
■
Check the device for damage before putting it into operation. The device should only
be used when it is undamaged and in working order! Do not use the device if it has
malfunctioned, fallen or been dropped in water. Have it checked in a specialist work-
shop before using it again.
■
Do not place the device on or next to heat sources such as hobs or ovens. Keep
naked fl ames away from the device and the connecting cable.
■
Do not expose the device to extreme temperatures, persistent moisture, direct sun-
light or impacts.
■
Make sure that the connecting cable is not squashed, bent or laid over sharp edges
and does not come into contact with hot surfaces.
■
Never place objects on the device or the connecting cable.
■
Use only original accessories from the manufacturer in order to guarantee that there
is no interference that may prevent the device from working and to avoid possible
damage.
Inserting / Removing Accessories
Lid
• Inserting: Insert the lid (
3
) into the top of the motor unit (
1
) and press it down until it
engages (Picture
C
).
• Removing: Press the release button (
11
) (Picture
D
). The lid is unlocked and can be
removed.
Cube Dicer
The lid (
3
) must be removed before inserting or removing the cube dicer (
8
) (see above).
• Inserting: Insert the cube dicer into the holder for cutting inserts (
13
) so that its blade
is facing upwards. Place the openings on the left and right next to the blade on the
two locking lugs in the holder for cutting inserts (Picture
E
). Press down the cube
dicer until it engages.
• Removing: Press the release button (
11
) and remove the cube dicer from the holder
for cutting inserts.
Slicer, Fine and Coarse Grater
The lid (
3
) must be removed before inserting or removing the slicer (
7
) and the coarse
grater (
6
) and fi ne grater (
5
) (see above).
• Inserting: Insert the respective cutting insert into the holder for cutting inserts (
13
) so
that its blade is facing upwards ( Picture
F
).
• Removing: Reach into the round openings of the cutting insert with your fi ngers and
pull it out (Picture
G
).
Collecting Container
• Inserting: Place the collecting container (
2
) into the bottom of the motor unit (
1
) and
twist it to the left until it engages (Picture
H
).
• Removing: Twist the collecting container to the right until it is detached from the motor
unit. It can then be removed.
