Device Description HG G-98780-A | English, Revision 16 | Date: 15.07.2021
37
Software – Chapter 6
Only the update program described below may be used for the software update!
6.3.1 Installation of the Program for Software Update
The program for the antenna software update is a 32-bit application for Microsoft®
Windows®. Upon request, this program is available either on disc (described in the
following paragraphs) or sent by e-mail. Please address your requests to the e-mail,
phone, fax or mailing address given on the cover of this manual.
It is not necessary to install this program. It is sufficient to copy it onto the hard disc
of your PC and execute it there. Follow these steps:
1.
Insert the CD into the CD drive of the PC
2.
Open Windows Explorer and navigate to the CD
3.
Copy the directory ST-Flash including all sub-directories and files onto your hard
disk, e.g. into the director ’programs’
4.
When using Windows-Versions prior to Windows XP, it is now necessary to
deactivate the writing protection for the two setting files. To do so, navigate to
the newly created directory Programs\ST-Flash and mark the files
ST10-Flas
-
her.ini
and
Command.log
. Open the function features (’Eigenschaften’)
within the file menu of the Explorer and deactivate the parameter
Writing
Protected
.
5.
In order to start the program now, carry out the file
ST10-Flasher.exe
.
6.3.2 Software Update
While the software update is carried out, no other programs may occupy the used
serial interface (COM-Port). Thus, terminate any such connections in your Terminal
program (e. g. Hyperterm).
Connect the antenna with your PC. For antenna variants with RS422 interface
(HG 98780ZA/XA) it is essential to use an appropriate interface converter (not in
-
cluded in the antenna scope of supply; refer to the note on the top of Seite 27). Start
the update program on your PC as described in section 6.3.1 on page 37.
