Device Description HG G-19370-B/HG G-19380-B | English, Revision 03 | Date: 05.05.2020
32
Chapter 10 – Technical Data
10
Technical Data
Table 16
Technical Data
Technical data inductive guidance sensor
Casing
156,5 x 53 x 21 mm (W x H x D)
Height including connectors: 70 mm
Polycarbonat (PC)
Weight
approx. 200 g
Protection Class
IP 54
Relative humidity
95% at 25° C (without condensation)
Temperature ranges
–
Operation: -20° C to +50° C
–
Storage: -20° C to +70° C
Supply voltage
5 V (USB, configuration)
Nominal (vehicle): 12 VDC – 24 VDC
Maximum: 10 VDC – 30 VDC
Current consumption
–
HG G-19370/80ZB (CAN): 60 mA @ 24 V
–
HG G-19370/80YB (Profinet): 110 mA @ 24 V
Reading height
40 – 200 mm
Nominal reading height 60 mm (preset)
Different reading distances via programmable gain
Frequencies
–
5 programmable guide wire frequencies, simultane
-
ously usable, 2 – 20 kHz, 100 Hz resolution
–
1 programmable frequency for an energy track (see
below)
Energy track
Two possible configurations (variants):
–
HG G-19370-B:
Frequency: 25 kHz, wire spacing: 140 mm,
wire current of the inductive energy transmission: 85 A
–
HG G-19380-B:
Frequency: 140 kHz, wire spacing: 110 mm,
wire current of the inductive energy transmission: 45 A
Measuring rate
100 Hz (every 10 ms a new value is calculated)
Connectors
3 M12 circular connectors
ST 1
8 pin male, A coded, supply, USB, incremental encoder
ST 2 / ST 3
–
HG G-19370ZB:
5 pin female/male, A coded, CAN bus
–
HG G-19370YB:
4 pin female, D coded, Profinet
USB
Configuration / firmware update
with emulation of a serial interface
Incremental encoder Input for the processing of an incremental encoder. All
incremental encoders can be used that have a switching
threshold > 10 V between high level and low level (typically
24V incremental encoders).
