Software
English, Revision 04, Date: 19.01.2015
43
5.3.2.9
(L)oad values to EEProm
This submenu enables saving the parameters within a non-volatile memory once the
corresponding pass word has been entered. This is necessary in order to accept the
current changes as permanent settings.
5.3.2.10 (U)pdate Firmware
This submenu offers the option of a software update without having to disconnect and
re-connect the power supply. However, first it is necessary to install the update pro-
gram as described in section 5.4 on page 44.
Then press
within the main menu. A display with the following instructions will ap-
pear:
1.
Close the COM-Port in Hyperterm using the icon
.
2.
Open the flash program
ST10-Flasher 2.exe
on your PC.
3.
In
ST10-Flasher 2.exe
select the COM-Port, via which the antenna is cur-
rently connected to your PC.
4.
Select the hex file to be programmed in
ST10-Flasher 2.exe
.
5.
Now return to Hyperterm, re-connect the COM-Port via the icon
and press
any key.
6.
Within the next 20 sec. close the COM-Port using the icon
, in Hyperterm,
switch back to
ST10-Flasher 2.exe
and start programming.
Once the programming is completed, return to Hyperterm, wait 10 sec. and re-con-
nect the COM-Port (e. g. via the icon
). Then re-start the monitor mode (also refer
to section 5.3.1 on page 31).
5.3.2.11 Import (1) / export (2) User Parameter
It is possible to store or load all user parameters on or from a host via XMODEM file
transfer protocol:
-
With
you can import a parameter file from a host. After pressing that key you
should start an XMODEM file transfer within 50 seconds. When using Hyperterm
go to
Transfer
>
Send file
>
XMODEM
>
File name
. If the message
Success
is
displayed the file has been checked and loaded in the parameter RAM. To pre-
serve the loaded values you should transfer them into the EEPROM (see 5.3.2.9
on page 43).
-
With
you can export user parameters to a host. After pressing that key you
should start an XMODEM file transfer. When using Hyperterm go to
Transfer
>
Receive file
>
XMODEM
>
Folder
and then specify a file name. The file is trans-
ferred and the message
Success
should be displayed.
5.3.2.12 P(r)int Parameters
Enables writing the system parameters into terminal program file (e. g. Hyperterm).
