Gotting HG 76342-A, Описание устройства

Страница: 15 / 23

WEB Interface
HG 76342-A
English, Revision 01, Date: 27.01.2014 15
3.1.4 LAN-Info
In this section the actual status of the both LAN ports is shown.
SNR SNR shows the „signal noise ratio“. The value can be interpreted by the
following rules:
Security The used security method is shown.
None
WEP
WPA(2)
EAP-PEAP (TTLS, TLS, LEAP)
Transfer statis-
tics This table shows some statistical values of the transceiver module.
Roaming Count This value tells the number of roaming cycles since the last reset.
Background
Scan Count If the radio reception is getting worse the device scans other channels for better
reachable access-points. The number of scan cycles are shown here.
Info Note
Port 1 (2) Down

no LAN cable is connected or the LAN Client is not
switched on
Up

LAN cable is connected, client detected
10 oder 100 MBit

transmission speed
full oder half duplex

simultaneous send and receive on or off
LAN-Client Table of the registered MAC addresses of client devices at the
LAN port.
Table 7
Info Page - LAN-Info
Info Note
Table 6
Info Page - WLAN-Info (part 2 of 2)
SNR State

40 very good radio reception

30 good radio reception

20 good radio reception but depending on the
configuration the device starts to scan
other channels for „better“ access-points

10 poor radio reception, the transmit rates
will be lowered. The device will scan other
channels to find „better“ access-points
< 10 very poor radio reception, the data
throughput will be lowered
Table 5
Quality of the reception signal