Hardware Development Guide
All Rights reserved, No Spreading without GOSUNCN Permission 24
ME3630 mini-PCIE
ME3630 mini-PCIE
Figure 4–6 PIN1(WAKEUP_OUT) output sequence
Module status
Operating state
Sleep state
low
High
WAKEUP_OUT
1s
4.7
W_DISABLE_N
S
IGNAL
The W_DISABLE_N signal (PIN No: 20) -- Active low, pulled up internally, input from a hardware switch to the module that disables
the main RF radio. Table below describes its control logic.
Table 4-5 Definition and Description of W_DISABLE_N Signal
W_DISABLE_N
Module Status
‘1’
RF is enabled.
‘0’
RF is disabled.
The reference circuit design of W_DISABLE_N signal can refer to the interface of RESET_IN signal.
NOTE: Do not directly connect this signal to the positive end of the power supply.
4.8
RESET_IN
S
IGNAL
The RESET_IN signal (PIN No: 22) is the system reset signal of the module, active low. Table below illustrates its control logic. Figure
below shows that pull down the reset key (RESET_IN) more than 1s will reset the module.
NOTE: Do not directly connect this signal to the positive end of the power supply
.
Table 4-6 Definition and Description of RESET_IN Signal
RESET_IN
Module Status
‘1’
Module is in the normal working status.
‘0’ and t≥1s
RF is in the OFF mode, Module will reset.
