Gost Phantom, Инструкция по установке и программированию

Страница: 23 / 23

GOST Phantom
–
Instal Programming Guide
support@gostglobal.com or (954) 565-9898 23
Table 3
Frequently Asked Questions ( F.A.Qs )
FAQ 1: The wireless Extension door contact, High Water
Alarm, and/or Battery low voltage sensor are non responsive
and not registering a condition change (open or close zone)?
Assure that when you programmed the device, you pressed the
tamper button twice within one second, see (See 08-System
Setup, 01-Zones)
FAQ 2: The GSM module connected via ring and tip to the
GSM/Data device is inoperative?
1.)
Confirm that the sim card is active with voice time
available for it (and data if using it for an internet
connection with GOST Watch HD)
2.)
Confirm that you have gone into sectional programming
to change the communication default from the onboard
module to the secondary GSM module. (See 08-System
Setup, 09-Communicator).
FAQ 3: The Onboard GSM Module will not stop displaying a
trouble for the unused
“Sim 2”.
This message comes up when
at one point of another a card has been placed in
“Sim 2”
. The
module needs a reset.
Go to section
“9002” to factory reset this module only. It will
then reboot the module and accommodate for only the sim
card inserted and leave the rest stagnant.
FAQ 4: The GOST Phantom is powered off of the AC to DC
transformer that is included with the system. The Voice
reporting is configured to report trouble for AC power
Loss/Restoration, thus when the Boat looses shore power a
call will be placed. I am not getting the call.
The Panel must be denied power for 15 minutes by default,
only then will the call be placed. If you want to change it to a
lower threshold, see section below
Go to section
“2027” and type in the variable you want from
01 to 255 minutes. Then continue to press
“#” until you see
“Exit” and press the right menu action key.