Gossen MetraWatt SSP 120 Series, Руководство по эксплуатации

Страница: 34 / 92

34 GMC-I Messtechnik GmbH
SEq – Sequence, Automatic Memory Recall
Functions
• Controls automatic and step-by-step sequence runs.
Setting Parameter
☞
Strt: select step-by-step control , jump to start address (status:
RDY

HOLD), execute command with the <ENTER> key.
☞
GO: select SEQUENCE , jump to start address and start (status:
RDY

RUN), execute command with the <ENTER> key.
Additional Setting Parameters
with running or suspended sequence, and in step-by-step mode
☞
hold: SEQUENCE runs stops at current address (status: RUN

HOLD), execute command with the <ENTER> key.
☞
cont: SEQUENCE is resumed at next address (status: HOLD

RUN), execute command with the <ENTER> key.
☞
StEP: execute next memory location and start (status: HOLD

HOLD), execute command with the <ENTER> key.
☞
StoP: SEQUENCE is stopped and jumps to stop address (status:
RUN

RDY or HOLD

RDY), execute command with the
<ENTER> key.
Settings
(see sequence settings and execution on page 35)
☞
Procedure for selecting SEq, ( see also chapter 4.7 ):
!
The SEq display appears in the window for the SEq function.
☞
Press the <ENTER> key in order to switch to the SEQUENCE
menu.
☞
Repeatedly press the <FUNCTION> key (max. 6 times) until the
SEq Go function appears.
Figure 4.7.3 i Preparing a SEQUENCE
☞
Acknowledge the sequence with the <ENTER> key.
Figure 4.7.3 j Preparing for Step-by-Step Control
!
The first valid memory location is now executed, and the
values saved to this location (
Uset , Iset and SSEt ) are read out
to the power output and the signal output.
The LOCKED/SEQ LED blinks slowly
.
Figure 4.7.3 k Preparing for Automatic SEQUENCE Control
!
In this case, all memory locations are executed, one after the
other, from the start address to the stop address, and the
respective values saved to each location (
Uset , Iset , tdef/tset
and SSEt ) are read out to the power output and the signal
output.
The LOCKED/SEQ LED blinks rapidly.
.
Note
!
Automatic and step-by-step sequence control (external trigger
or setting command) are
not interlocked .
!
After the SEQUENCE run has been started, various error
messages may appear for a period of approximately 1 second
(see also page 36 and the appendix).
!
If an error occurs during execution of the sequence , bit 5 SEQE
(SEQuence Error) is set in event register B (ERB).
☞
The procedure shown in Figure 4.7.3 l must be used for
setting up and starting
sequences for SSP KONSTANTERs with
software version < REL. 003.
In this case, sequences can only be set up and started if the
SEQ ON test parameter has been selected after entering the
SEq menu.
Figure 4.7.3 l SEQUENCE preparation with software
version < REL. 003
Select the text parameter
from an options loop
From the SEq function group
*
ENTER
CE/LOCAL FUNCTION
Continue in the SEq function group
ENTER
FUNCTION
+
Jump to the start address or the
first address with valid contents
Step-by-step control
LOCKED/SEQ
LOCKED/SEQ
Continue in the SEq function group
ENTER
FUNCTION
+
Sequence running LOCKED/SEQ
LOCKED/SEQ
Select the
from an options loop
From the SEq function group
*
ENTER
CE/LOCAL FUNCTION
ENTER
ENTER
text parameter