GORMAN-RUPP 62-1/2E13-4A084, Техническое руководство, Страница: 55 / 107

b. Cleaning and Inspection.
—
(1) Clean all parts in an approved cleaning solvent;
dry thoroughly.
(2) Inspect all parts for cracks, breaks, or other
c. Reassembly and Installation.
—
(1) Refer to figure 3-9 and reassemble the muffler
and exhaust primer.
(2) Refer to figure 3-8 and install the muffler and
damage. Replace damaged parts. exhaust primer.
.
Section VI. FUEL SYSTEM
3-17. GENERAL (2)
The fuel system, which consists of the fuel tank,
shutoff cock, and fuel hose, supplies fuel to the engine
fuel filter. Fuel is drawn up from the skid-base-
mounted fuel tank by the fuel pump on the engine.
(3)
3-18. FUEL TANK, LINES, AND FITTINGS
a . Removal and Disassembly. Refer to figure 3-10 (4)
and remove and disassemble the fuel tank lines and
fittings.
b. Cleaning and Inspection.
—
.
Inspect fuel tank for cracks, breaks, leaking,
and other damage. Repair or replace damaged
tank.
Inspect the fuel hose for cracks, deterioration,
kinks, restrictions, and other damage.
Inspect all fuel fittings for cracks, damaged
threads, and other damage. Replace damaged
parts.
c. Reassemble and Installation. Refer to figure 3-10,
(1) Clean all parts with an approved cleaning solvent; and reassemble and install the fuel tank, lines, and
dry thoroughly. fittings.
Section VII. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
3-19. GENERAL 3-20. PUMP
This section provides information for removing the Note. This procedure is intended for use when it is
pump and engine from, and installing them on, the necessary to remove the pump for replace-
skid base. ment purposes only. When overhauling the
Figure 3-11. Pump, removal and installation.
3-11