F
3.
PROGRAM / DELETE / EDIT SENDERS
3.1
Entry into the programming mode.
1.
LED must flash.
F
+
2. Press
F
until the LED remains lit and on.
3.
Press
4.
The F key can be released and immediately release the key (in maximum 0,5 s).
5.
Enter password – display YES (enter the wrong password - long beep).
3.2
PROGRAMMING TRANSMITTERS TO PAGER MEMORY.
1.
Enter the programming mode(3.1).
2.
Keys - / select a cell memory - flashing - - - - (four lines) mean free cell
3.
Press -
F
and let go – displayed: . (dot)
4.
Press - and let go – displayed: - (dash)
5.
Send a signal from the transmitter * – display: - - (two dashes)
6.
Resend the signal from the transmitter - display: - - - (three dashes), and then flashing: 0 0 0 0 (four zeros) which
means the correct registration of the transmitter. NO message indicates an error so you should repeat steps 3-6.
7.
Press -
C
–
exit from programming mode.
If you need a one-time registration of more transmitters, you must repeat steps 2-6, and finally
perform point 7. Hold down - or for more than 3s, you can quickly view memory.
Warning! Each button remote control is treated as a separate transmitter which means the need for
programming into PAGER memory all keys on the remote control if they all have to be recognized by PAGER.
*
Programming the remote control or a button press 201 PNH, a programming fixed transmitters trigger the transmission
,
eg.
press TEST.
MESSAGES ON DISPLAY:
- - - - (Four lines) memory cell is free
F U L memory cell occupied by a transmitter
N O mis-recording of the transmitter
J E S T
transmitter is already programmed in the memory
A K U Lo low power state
Lb low battery transmitter
3.3
DELETE transmitters from the memory of PAGER.
F
+
C
1.
Enter the programming mode as 3.1.
2.
Keys -
/
specify a transmitter memory.
3.
Press -
F
and let go, dot on the display
4.
Press -
C
and let go, will be displayed flashing - - - - (four lines), which means
erase a transmitter from the memory.
5.
Press -
C
- the reset mode.
If you need to delete more transmitters, repeat point. 2-4, and finally perform point 5
.
3.4.
Edit - transmitter DESCRIPTION.
1.
Enter the programming mode as in 3.1.
+
2. Keys -
/
specify a transmitter memory location.
3.
Press -
F
and let go it displays a dot.
4.
Press - and let go – first item on display blinks.
5.
Keys -
/
select the desired character or number.
6.
Press -
F
it goes to next position on display.
7.
Press -
C
to exit the menu transmitter name entry.
8.
Second press
C
exits edit transmitter mode.
If you need to enter descriptions for more transmitters, repeat point. 2-7, and finally point 8.
Page: 2 of 4
