17
as the radio interference suppression
regulation.
Do not use a vacuum cleaner on the site.
Absorbed building material can damage
your appliance.
When you are using the vacuum cleaner
together for several hours, pull the
connecting cable to the end.
Noise level:
Lc < 84 dB(A)
CAUTION: Never use the vacuum cleaner
without the filters.
Vacuum cleaner use only for home and in the
inner rooms!
Do not use a vacuum cleaner in very dirty
places, it will immediately obstruct HEPA
filter!
Connection to the mains
supply
Check, please, whether the voltage stated on the
data plate comply with the data of your house
mains supply.
Supply cord
If the supply cord is damaged, it must be
replaced with the suitable cord, or a set for
coiling the cable, which you can get in the
nearest Gorenje’s service outlet.
Data on compliance with
european standards
Test for this type of appliance confirmed that it
complies with the following European directives:
73/23/EEC Low voltage
93/68/EEC CE Marking
89/336/EEC Directive on Electromagnetic
Compatibility
– EMC
This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment
(WEEE). This guideline is the frame of a
European-wide validity of return and
recycling on Waste Electrical and
Electronic Equipment.
Elimination of the appliances
and environment
If one day you decide to change your appliance,
or you just do not need it any more, think about
the environmental protection.
Vacuum cleaner assembling
Always remove the plug from the power supply
before fitting or removing accessories. Before
putting the appliance into service, please check if
all filters are inserted correctly.
ASSEMBLY OF THE SUCTION HOSE
Insert the flexible suction hose into the
connection opening at the top of the
housing until you can feel it lock.
HOSE REMOVING
To remove flexible hose from the vacuum
cleaner, press the buttons situated on the
flexible hose base, then pull to remove it
from the attachment point.
ROLLING THE CABLE OUT AND UP
Pull out the cable to such a length that easy
working is ensured. Now connect the
appliance to the main supply. Press the
switch to activate the automatic rewinder
and hold on the mains plug for safety
reason.
FITTING TUBE AND ACCESSORIES
Extend the tube to the desired length by
pressing on button.
Insert a flexible hose into a tube.
Fit a nozzle to tube:
-
Floor brush is intended for cleaning
bare floor and floor coverings.
-
Crevice/furniture nozzle is for cleaning
corners and between cushions.
According to the mark rotate the nozzle
to brush position to clean curtain or
dust on the decorating surfaces.
Instruction for use
Before using the appliance, unwind a
sufficient length of cord and insert the plug
into the power supply.
Press the On/Off button to switch the unit
on. To stop it press the On/Off button again.
You can adjust the air flow using the air flow
regulator on the flexible hose:
-
decrease power for cleaning curtains,
books, furniture, etc.
-
increase power for cleaning bare floor.
To rewind the cord, press the rewind button and
guide the cord with hand to ensure that it does
not whip causing damage.
