17
putting the appliance into service, please check if
all filters are inserted correctly.
ASSEMBLY OF THE SUCTION HOSE
•
Insert the flexible suction hose into the
connection opening at the top of the
housing until you can feel it lock.
HOSE REMOVING
•
To remove flexible hose from the vacuum
cleaner, press the buttons situated on the
flexible hose base, then pull to remove it
from the attachment point.
ROLLING THE CABLE OUT AND UP
•
Pull out the cable to such a length that easy
working is ensured. Now connect the
appliance to the main supply. Press the
switch to activate the automatic rewinder
and hold on the mains plug for safety
reason.
FITTING TUBE AND ACCESSORIES
-
Extend the tube to the desired length by
pressing on button.
-
Insert a flexible hose into a tube.
-
Fit a nozzle to tube:
-
Floor brush is intended for cleaning
bare floor and floor coverings.
-
3 pcs. set of nozzles are appropriate
for cleaning corners and other small,
inaccessible places.
Instruction for use
•
Before using the appliance, unwind a
sufficient length of cord and insert the plug
into the power supply.
•
Press the On/Off button to switch the unit
on. To stop it press the On/Off button again.
•
You can adjust the air flow using the air flow
regulator on the flexible hose:
-
decrease power for cleaning curtains,
books, furniture, etc.
-
increase power for cleaning bare floor.
To rewind the cord, press the rewind button and
guide the cord with hand to ensure that it does
not whip causing damage.
Maintenance
1. Changing of the dust bag
•
Always operate the cleaner with dust bag
installed.
•
If you forget to attach the dust bag or attach
it in the wrong manner, the dust cover may
not close completely.
1.
After removing the flexible tube, open the
front cover.
2.
Rotate the support of the bag to the correct
position.
3.
Remove the dust bag.
4.
Replace the bag when it is full of dirt and
put in a new one.
5.
Close the cover by passing down unitil it is
locked.
2. Cleaning filter
1.
Open the cover for HEPA filter.
2.
When open the cover for HEPA filter, use
your two fingers pulling ouch for HEPA,
then pulling HEPA up.
3.
Take the HEPA out and change a clean
one.
4.
Close the cover for HEPA filter.
