Instructions for use, installation and connection
48
Alarm timer
(certain models only)
Maximum setting time is 60 minutes. After the expiry of set
time alarm sound is heard, lasting for about five seconds.
Timer is set by turning the knob in clockwise direction, and the
correct setting is obtained by turning it anti-clockwise.
Gas cooking zones
There are no special measures to be taken prior first use of
gas cooking zones.
Electric hotplates
(certain models only)
Turn the hotplates on at maximum power for 3 to 5 minutes
without any dishes, in order to smoke them out. This procedure
aims to reinforce the protective film upon the hotplate surface.
Gas burner control
Cooking burners are controlled by the relevant control knobs.
Heating power is indicated on the knobs by the large flame
symbol and the small flame symbol.
Always turn the knob over the large flame position towards the
small flame position and back. The operating position is always
between the two flame symbols.
Safety cautions in regard to the cooking zones
•
Never use cooking zones without dishes, or for heating the
ambience!
•
Keep the cooktop clean, since dirt and stains have adversary
effect on the functionality of burners.
•
If you like your food to be crisp, first set the burner to the
maximum and continue cooking at minimum power.
•
Always provide adequate quantity of water when cooking in
the pressure cooker. Lack of water may cause damage to
the dish and to the cooker.
•
Cooktop burners are thermally protected. If the burner
flame is accidentally extinguished (spilled food, gust of
wind) the gas supply is automatically shut. There is no
possibility of gas escaping into the room!
•
If the flame of thermally non-protected cooking burners
is accidentally extinguished, the gas escapes into the
room!
•
Be very precise when placing the burner crown cap upon the
crown. Always keep the crown nozzles clean and free.
crown cap
thermal coupling
(certain models only)
ceratin models only
burner crown
correct position of burner
components
Ignition and operation of burners
Gas burners may be ignited by means of electric ignition spark
plug, fitted adjacent to each burner (certain models only).
Single handed ignition
(certain models only)
To ignite the burner, press the selected burner button and turn
it to the maximum power position . Electric spark from the
ignition device ignites the gas. If the ignition device is out of
order, either due to power failure or humid ignition device, use
a match or a lighter to ignite the gas.
Ignition with both hands
(certain models only)
To ignite the burner, press the selected burner button and turn
it to the maximum power position . Now press the ignition
device button. Electric spark from the ignition device ignites the
gas.
If the ignition device is out of order, either due to power failure
or humid ignition device, use a match or a lighter to ignite the
gas.
•
Keep the button pressed for approximately 10 seconds after
ignition to stabilize the flame.
•
If you failed to ignite the burner after 15 seconds, shut
the burner off and wait for at least one minute before the
next attempt
.
•
After that you can set the burning power between high and
low position to suit your cooking requirements.
•
Button positions between in are not recommended. In
these positions the flame is not stabilized and may be
extinguished.
•
If the flame goes out repeat the procedure.
•
!
If the burner flame goes out (for whatever reason), shut the
burner off and wait for at least one minute before next
attempt.
•
Note: before igniting the burners (triple-ring burner, double-
ring burner, and Mini Wok) cover them with appropriate
cookware.
•
To shut the burner off turn the button to the right, to the OFF
position
(CLOSED).