Half load
This option adapts the dishwashing program to a half-full
dishwasher, and uses less energy and water.
Delayed start
When you select Delayed start the dishwasher will start 1-
24 hours after you close the door.
1
Press the button once to activate Delayed start. Press
the button several times – or hold it in – to set the de-
sired number of hours.
2
Close the door and the dishwasher counts down 1 hour
at a time and starts after the selected delay.
If you want to cancel the Delayed start option, open the door
and press and hold the main power switch until the display
turns off.
Starting the dishwasher
Close the door to start the dishwasher. If the main power
switch is on, the dishwasher will start automatically when
the door is closed.
TIME - Time remaining
Once you have chosen a program and options, the time the
program took when last used is displayed.
Once you have started the dishwasher, the display shows
the remaining program time. The remaining time is updated
after the water for the final rinse has been heated.
This may differ somewhat from time to time depending on
the temperature of the water supply, the amount of dishes,
the ambient temperature and other factors.
Front display
Dishwashing
Time remaining
Drying
Stopping or changing a program
If you want to change program after starting the dishwasher,
open the door, then press and hold the main power switch
until the display turns off. Add more detergent if the lid of
the detergent dispenser has opened. Then press the main
power switch, choose a new program, and close the door.
Do you want to add more dishes?
Open the door. The dishwasher stops automatically. Add
the dishes and close the door. After a while, the dishwasher
continues the program.
If the dishwasher is turned off due to a
power failure
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is
cut or the door is open for more than 2 minutes.
How to get the best drying results
•
Fully load the dishwasher.
•
Angle dishes with hollows, such as cups, so that the
rinse water will run off. This is also important for plastic
items.
•
Top up with rinse aid or increase the rinse aid dosage
level.
•
Activate the Extra dry option.
•
Open the door a little once the program has finished.
•
Allow the dishes to cool before unloading the dishwash-
er.
Once the program has finished
Once the program has finished, “End” appears on the dis-
play.
The dishwasher switches off automatically after the program
ends. Turn off the water tap after each use.
Drying
For additional drying the door should be opened 35 mm
upon completion of the drying cycle. For more information,
see page 20 in the chapter Technical information.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in
the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from
the upper basket falling onto the dishes in the lower basket.
7
Содержание GS63160SAU
Страница 1: ...AU OPERATING INSTRUCTIONS DISHWASHER...
