Gorenje GDV674X, Руководство по эксплуатации

Страница: 12 / 32

TIME REMAINING
Once you have selected a programme and
options, the display indicates how long the
programme took the last time it was used. The
remaining time is updated after the water for the
final rinse has been heated.
This may differ somewhat from time to time
depending on the temperature of the water
supply, the amount of dishes, the ambient
temperature and other factors.
NOTE!
During the first run of each programme, the
remaining time displayed can be slightly
misleading, as the dishwasher is estimating the
time. When you run the programme a second
time, the dishwasher will calculate the remaining
time based on the previous duration of the
programme.
STATUS LIGHT
The status light at the bottom on the dishwasher
provides information by means of 3 different
colours. Adjust the status light so that it is seen
clearly by pulling out or pushing in the transparent
plastic strip.
Status light
Blue
Load more. The programme has started, but you
can still load more dishes.
Red
Do not load. You should not load more dishes
(risk of poorer dishwashing result).
Flashing red
This indicates a fault. See further in the section
Troubleshooting.
Green
Unload. The dishwashing programme is finished.
Standby light for two hours.
STOPPING OR CHANGING A
PROGRAMME
If you want to change programme after starting
the dishwasher, open the door then press and
hold Start/Stop for three seconds. Add more
detergent if the lid of the detergent dispenser has
opened. Then choose a new programme, press
Start/Stop and close the door.
DO YOU WANT TO ADD MORE DISHES?
Open the door. The dishwasher stops
automatically. Add the dishes, close the door and
the dishwasher continues the programme.
IF THE DISHWASHER IS TURNED OFF
USING THE ON/LEFT-ON MODE BUTTON
OR DUE TO A POWER FAILURE
If the dishwashing programme was not finished,
the interrupted programme continues when
power is restored.
NOTE!
During drying, the programme is interrupted if
the power is cut or the door is open for more
than 2 minutes.
ONCE THE PROGRAMME HAS FINISHED
Once the programme has finished and the door
is opened "End" appears on the display.
At the end of the programme one short signal
will sound. Chapter Settings describes how to
change this function.
A status light also indicates the end of the
programme. See the section Status light in the
chapter Using the dishwasher.
Once the dishwasher has finished, it uses only
standby power. Shut off the water tap after every
use.
12