Gorenje GBU 100 EDD/V6, Инструкция по эксплуатации, Страница: 20 / 24

20
Continue pressing the key and select the three operating modes:
- protection against freezing (factory water temperature set to 7ºC)
-
cost saving operation (factory set to 55ºC)
- optional manual setting of temperature in the range from 35ºC to 75ºC, (increments of
1ºC)
Protection against freezing:
- Use the key and select the operating mode (yellow control lamp under is on)
- The regulator is set to temperature 7ºC – shown on the display
Cost saving operating mode:
- Use the key and select the operating mode (yellow control lamp under is on)
- The regulator is set to temperature 55ºC – shown on the display
Manual temperature setting:
- Use the key and select the operating mode (yellow control lamp under is on).
- The display always shows the last setting of the water temperature; except on irst turn on
of appliance when factory setting 35ºC is displayed.
- Use the or key to select new temperature. By pressing the key you increase/
decrease the temperature by 1ºC. Holding the key will speed up the process.
- After desired water temperature is set, the display lashes for 3 seconds and then shows
the current temperature again.
- In case of interruptions in power supply, the appliance resumes operating with the settings
adjusted before the interruption.
INDICATION:
• Control lamps:
- Heating element operation
: Green control lamp:
- the heating element is on – the lamp is on
- the heating element is off – the lamp is off
- Mg anode : Red control lamp:
- the lamp is off – anode is active
- the lamp is on – anode may be worn out
Warning! When the water heater is out of use for longer period of time, the signal lamp may
indicate that the Mg anode is worn out in spite of the fact that the Mg anode is still active.
In this case open the hot water tap (fresh water low into water heater). If the signal lamp
switches off, the water heater operation is not impaired. If not, call the nearest authorized
service provider
EN