302967
Required tools: socket spanner nr. 8, screwdriver, torx 25
Caution! After unscrewing of before
fi
xing hinges, hold the door
to prevent it from falling and damaging.
1.
Remove upper hinge cover (keep it for eventual later
use), together with cover on the opposite side of the
upper hinge cover (on the opposite side you will insert
the attached cover during the assembly), and remove the
cover on the opposite side of the upper part of the door.
2.
Unscrew upper hinge screws and remove the door from
the bottom hinge.
3.
On the bottom side of the door unscrew the swing stopper
screws and remove the stopper (A). Keep this for later
use. Fix the attached stopper with its bearing on the
opposite side of the door.
4.
Unscrew the forced door closure system (B) and
fi
x it to
the opposite side of the door (certain models only).
5.
Tilt the appliance backward (max. 35°) to lean to the rear
side of the cabinet. Unscrew the leg support screws
(C) - left and right, and remove the leg support cover
(D). Unscrew and remove, then reciprocally replace
the position of end switch (E) and decorative peg (F)
(for models with forced door closing system). Place this
on the opposite side. Unscrew three screws
fi
xing the
bottom hinge (keep this for possible later use), and
fi
x
the attached bottom hinge on the opposite side.
6.
Proceed with the assembly procedure in opposite sequence.
Note:
In appliances with the handle along the entire height of the door,
the reverse door swing is not possible.
Version III
11
Downloaded from Fridge-Manual.com Manuals
