Gorenje CJ100HE, Инструкция по эксплуатации

Страница: 13 / 43

13
Check if the voltage indicated on the bottom of
the appliance corresponds to the local mains
voltage before you connect the appliance.
If the mains cord is damaged, you must have it
replaced by Gorenje; a service centre
authorized by Gorenje or similarly qualified
persons in order to avoid a hazard.
Do not use the appliance if the plug, the mains
cord or other parts are damaged.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instructions
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Never connect this appliance to an external
timer switch or remote control system in order
to avoid a hazardous situation.
Always unplug the appliance after use.
Never connect this appliance to an external
timer switch or remote control system in order
to avoid a hazardous situation.
Noise level: Lc < 60 dB(A)
This appliance is marked according to the
European directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE). This guideline
is the frame of a European-wide validity of return
and recycling on Waste Electrical and Electronic
Equipment.
Preparing for use
Caution
Always place the appliance on a flat, stable
surface.
Do not use the citrus press longer than 5
minutes without interruption.
This appliance is intended for household use
only.
Never use any accessories or parts from other
manufacturers unless they are authorized by
Gorenje. In case you use these accessories the
warranty will be cancelled.
Before use
Clean all detachable parts before using the
appliance for the first time (see chapter
‘Cleaning’).
Make sure the appliance is assembled properly
before you plug it in the wall socket. Wind
excess cord round the base of the appliance.
Put the plug in the wall socket.
Before first use
Danger Keep the packaging material away
from children .they could suffocate
Unpack the citrus juicer and remove all of the
packaging
Material Examine the juicer for visible damage
and check that all of the parts are present
You should clean the appliance before using it
for the first time
Wipe the motor base with a damp cloth
Before using the juicer for the first time, rinse
the cones, strainer, juice container
and transparent dust lid with warm water and a
few drops of washing-up liquid.
Using the appliance
Setting up the juicer
Stand the appliance on an even surface that is
easy to clean
Unwind the power cord
– to the length you
require
– from the cord storage compartment
(underneath the juicer). Make sure that the cord
is correctly positioned in the cord guide to
prevent the juicer from wobbling.
Connect the mains plug to a AC230V,50Hz
socket outlet.
Selecting accessories
Depending on the size of the fruit you are
juicer, you can use the large or the small cone
The large cone is suitable for juicing small
citrus fruit ,such as grapefruit, oranges etc
The small cone is suitable for juicing small
citrus fruit, such as lemons, limes etc.
Fit the small juicing cone directly onto the drive
shaft
If you wish to use the large cone, fit the small
cone onto the drive shaft. Then fit the large
cone over the top of the small cone.
You must feel the notches in the large cone clip
into place over the stirring wings on the small
cone.
To separate the cones, pull the large cone up
and off.
Juicing
Caution: if you apply too much pressure to the
juicing cone, the motor may seize.
Fit the appropriate cone onto the drive shaft.
If you wish to collect the juice in the container,
press the spout upwards to close it.
If you want the juice to run straight into a glass,
press the spout downwards to open it and
place a stand under it.
Cut a citrus fruit in half and press the cut end of
one fruit half onto the cone. The juicer switches
on automatically when you press the fruit down
and the cone starts to turn. The juicer
automatically switches off as soon as you
reduce pressure on the cone. The cone