Gorenje 732270, Инструкция по эксплуатации, Страница: 4 / 33

EN
OPERATIN INSTRUCTION
[Inspection before start]
1.The power cord shall not be damaged or fractured.
2.Please verify the rated current of the power socket is in line with the requirements in the table
above and is equipped with a safety grounding device before use; otherwise, replace the
socket.
[Operating Instructions]
<Work/Standby>:Plug in the power,the buzzer will “beep” for along time,press the standby key
“ ” to enter the high-grade heating working state,and then press the standby key “ ” to
enter the standby state.
<Gear selection>: For work status, press “MODE” key to select one of work modes such as
high gear, medium gear, low gear and energy saving gear.
<Temperature Setting>:Under the working status,press and hold the“ ”key or“ ”key
to set the temperature,press and hold the
“ ”key or the“ ”key to quickly set the
temperature;after setting the temperature,have non-operation for 5 seconds,exit the
temperature setting screen.After the initialuse or memory clear,the whole machine runs
according to the factory settings.The default setting temperature is 35° C and the gear position
is high-end.
<Scheduled work>:Tap the timer key" " in standby mode to enter the scheduled
work setting screen. Press“ ”key or “ ”key to set the scheduled time, press“ ”key
or“ ”key for along time to quickly set the scheduled time,and the scheduled time will reach
the working status of the machine.The buzzer will ring with along beep.
<Scheduling standby>:Under the working status,press the timer key " " to enter the
scheduling standby setting screen.Press
“ ” key or “ ” key to set the scheduling time,
press
“ ” key or “ ” key for along time to quickly set the scheduling time,and the
scheduling time is in the standby state to the machine.
A:the scope of scheduling is for 0~24hours,and press " " key or " " key each time to
increase or decrease 1 hour.When the set value is 0H,press the " " key to set the time for
24H.When the set value is 24H,press the " " key,and the setting time is 0H.When the set
value is 0H,the scheduling is canceled. When the set value is not 0H,the scheduling is
started.Set the appointment time,press the timing key " " key or "MODE" key,or without
operation for 5 seconds,exit scheduling mode.
B:If the scheduling time isset,press the standby key " " to enter the standby state and
cancel the scheduling.