7
Installation procedure
(with springs)
x
Worktop must be absolutely horizontal;
x
Seal the cut surfaces with a suitable sealant to avoid swelling caused by moisture. The
sealant must be heat resistant;
x
Put the supplied springs in their places;
x
Feed the mains connection cable down through the cut-out;
x
Insert the appliance into the cut-out;
x
Press the appliance firmly towards the worktop from above.
Installation procedure
(with fixing brackets)
x
Worktop must be absolutely horizontal.
x
Seal the cut surfaces with a suitable sealant to avoid swelling caused by moisture. The
sealant must be heat resistant.
x
Feed the mains connection cable down through the cut-out.
x
Insert the appliance into the cut-out.
x
Centre the appliance in the cut-out.
x
Fix the appliance to the worktop by means of the brackets and accessories provided.
Holes are provided in the bottom of the tray where you can attach the screws
C
that
hold the brackets
B
in place.
CONNECTING TO THE POWER MAINS
x
The appliance may
ONLY
be connected by an authorized qualified technician.
x
Electric system protection should comply with all relevant regulations.
x
The connection clips can be accessed when the connection clip covers are opened /
removed.
x
Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home network. Connection voltage should be
checked by a qualified technician using a corresponding measuring device!
x
The rating plate with basic information is attached on the lower side of the appliance.
x
In order to make a fixed connection to the mains, insert an all-pole circuit breaker
between the appliance and the mains. This device shall have a contact separation in all
poles, providing full disconnection under overvoltage category III conditions.
x
The current conducting and isolated parts must be protected from any possibility of
direct contact.
WARNING!
x
Before any intervention, disconnect the appliance from the power mains. Connect the
appliance in compliance with the electric connections diagram supplied; make sure the
relevant network voltage is observed!
x
The ground wire should be connected to the clip indicated by the earth symbol.
x
The mains cable should be fed through the fastening clip which protects it from being
accidentally pulled out.
x
After connecting the appliance, turn on all cooking zones / heaters for approximately
three minutes to make sure they are operating correctly.
x
Incorrect connection may destroy parts of the appliance, making the warranty void.
x
Connection cable on the back of the appliance should be led in such way that it does
not touch the appliance back wall, as this part will get very hot during operation.
Wiring diagram
The following cables must be used for connection:
x
H05RR-F , 3x0,75mm
2
x
H07RN-F , 3x0,75mm
2
x
H05V2V2-F , 3x0,75mm
2
LIVE
L
BROWN
EARTH
GREEN / YELLOW
NEUTRAL
N
BLUE