SKU 93140
For technical questions, please call 1-800-444-3353
PAGE 5
To Assemble As A Wall Mounted Unit:
1.
Place the Wall Mount (6) at the desired location against the wall and use the Wall
Mount as a template to mark the position of two 1/4” diameter holes to be drilled.
(See Figure B.)
2.
Drill two 1/4” diameter holes and insert the Wall Plugs (9) in the holes.
CAUTION:
When drilling holes always first make sure no electrical cables or
wires are in the drilling path. Then, secure the Wall Mount (6) to the wall using
two Wall Mount Screws (8).
(See Figure B.)
3.
Slide the Body (2) of the Soap Dispenser downward onto the Wall Mount (6).
(See Figure B.)
To Install Batteries:
1.
Remove the Battery Cover (3) from the Body (2) of the Soap Dispenser to expose
the Battery Compartment. Install four “AA” alkaline batteries, making sure the
polarity (“+” and “--”) of the batteries match that as shown in the Battery
Compartment. Then, replace the Battery Cover.
(See Figure A.)
OPERATING INSTRUCTIONS
1.
Raise the Lid (1) of the Soap Dispenser and fill the unit with up to 16.9 fluid
ounces of liquid soap, shampoo, or lotion
.
Then, close the Lid.
(See Figure A.)
2.
Place your hand under the Sensor located on the underside of the Body (2) to
automatically dispense the liquid soap, shampoo, or lotion.
NOTE:
When the
WALL MOUNT (6)
BODY (2)
WALL PLUG (9)
WALL MOUNT SCREW (8)
FIGURE B
