Gopel Electronic basicCON 4113, Руководство пользователя

Страница: 5 / 15

Installation
USB 4113/ basicCON 4113 – User Manual 1-1
1 Installation
1.1 Hardware Installation
We recommend to install the device driver software before
connecting the device to the PC/ Laptop.
The USB 4113 board can only be operated when it is installed in one
of the GOEPEL electronics USB Racks USB 1004 , USB 1008 or USB 1016 .
USB 4113:
Please make absolutely certain that all of the hardware installation
procedures described below are carried out with your system
switched off.
Select an empty slot of your USB Rack . First remove the slot sheet
covering the slot (if mounted). To do that, loose the two screws.
Insert the board carefully via the guides into the prepared slot.
Push it finally into the slot till to the arrester by applying a little
pressure.
Then, tighten the two outer screws at the front panel to fix the board.
When installing the board, touch it at its edges only.
Never touch the surface of the board, because otherwise it may be
destroyed by electrostatic discharge.
To remove the board from the USB Rack (if necessary), unscrew the
two outer screws. By the lever at the front panel the board can be
dissolved from the slot and then be unplugged.
basicCON 4113 can be directly connected to the PC or Laptop.
BasicCON 4113:
Connect the USB female at the device’s rear side to the PC/ laptop
using the supplied USB cable.
If necessary, see chapter
Power Supply , connect the supplied power
supply unit or an own voltage source to the corresponding
ext. Power
Supply connections at the device’s rear side.
Please refer to chapter Addressing regarding the addressing of
several USB 4113 boards.
Please refer to chapter Connector Pinout regarding the connections
at the device’s front side.