ADJUSTMENT OF SPRING TENSION
1. Pull out approximately 6ft or 2m of hose and allow the drum to latch.
2. Remove hose stopper from hose, and feed hose back through guide.
3. Wrap the pulled hose one time around the drum to increase tension or un-wrap hose one
time from drum to decrease tension.
4. Re-insert hose through guide, and install stopper onto hose end.
5. Unlatch the drum and check tension. Pull hose from reel, and adjust stopper position if
necessary.
REPLACEMENT OF SWIVEL SEAL
Note:
There are two types of swivel arrangements.
1. Turn off and disconnect supply line from swivel inlet.
2. Remove swivel assembly from reel axel.
3. Hold fitting body in a vice. Remove brass tube from body, and remove swivel nut from tube.
4. Replace the seals and reassemble swivel. Apply pipe sealant to brass tube threads,
thread into fitting body and tighten.
5. Re-connect swivel to reel axel, and tighten.
Note:
Apply sealant to swivel nut before threading into axel.
6. Re-connect inlet supply line.
REPLACEMENT OF HOSE
1. Turn off supply to reel.
2. Pull out all of the old the hose and lock the reel in this position. Caution: Make sure reel
drum is securely locked and cannot rotate back.
3. Carefully disconnect hose from male fitting in axel center, and remove old hose.
4. Feed new hose through guide and opening in drum, and connect to male fitting.
5. Install stopper on other end of hose in the same position as before.
6. Carefully release the drum latch, and slowly allow the hose to wind onto the Reel.
Note:
Final spring adjustment is accomplished by adding or removing wraps of hose around
the drum. (Details see spring tension adjustment).
SPRING CANISTER WARNING
If the rewind spring fails for any reason: For safety reasons, the manufacturer strongly
recommends the replacement of the spring canister be carried out by a professional mechanic.
LIMITED WARRANTY
1. The manufacturer warrantees this hose reel against defects in material and craftsmanship,
for a period of 12 months from date of purchase.
2. Hose, if supplied with reel, O-rings, plastic rollers and rubber stopper are deemed to be
normal wear items; not warranted.
3. Manufacturer’s liability is limited to replacement or repair of defective material within the
warranty period, when returned freight prepaid to the distributor or their designated service
depot.
4. The warranty does not cover damage caused by accident, misuse or faulty installation.
5. The reel must be installed and maintained in compliance with the instructions.
E3
TECHNICAL
DETAILS
SAFETY
PRECAUTIONS
OPERATION
LIMITED
WARRANTY
EXPLODED AND
PARTS LIST
INSTALLATION
