1.When the configuration is complete, unplug the network cable to the Ethernet port of the computer and
plug it into the router.At the same time can restore the computer's lP address and other parameters to the
default Settings. lf the user wants to restore to dynamic lP mode, please press the RELOAD button for about
4 seconds. EzLogger Pro's LED lights will flash from left to right and reset to restart. EzLogger Pro will be
switched to dynamic IP mode after restart.
2.Protocol selection
Users can choose the protocol according to their needs. The gray one is the current protocol.After the
protocol is switched,promate waits about one minute before proceeding.
Note: if the protocol is switched, the inverter device should be restarted.
Connect the fiber jumper or tail fiber from the end boxes at both ends of the fiber to the ports of the gigabit
fiber switches (or the gigabit fiber interfaces of the transceiver or router at one end), Note that both ends of
the same optical fiber must be connected to the TX and RX ports of the optical fiber interfaces at both ends,
otherwise the optical fiber cannot be connected, and the single fiber module only needs one core optical
fiber jumper.
Note:when optical fiber group ring network, there must be only one root node in one ring network, and the
others are slave node devices.
lf the choice of fiber version please refer to this description
Some parameters of fiber optic switch: fiber optic switch is single-mode single-fiber,fiber interface SC,
central wavelength 1310/1550nm;The transmission distance is 20KM
4.3 Optical fiber switch configuration instructions
4.3.1 Use steps of optical fiber switch
4.3.2 The gigabit network switch indicator lights are all defined as follows
4.3.3 Reset and restore factory equipment
4.3.4 Introduction to the use of the Ring Network
PWR
RUN
FXL1
FXL2
1000M
ACT
Power indicator
System operation indicator
FXL1 Light mouth indicator light
FXL2 Light mouth indicator light
Network light
Network light
The lights indicate the power supply is normal
Slow Flash:The system is running well, flash, and the loop function is enabled
Light: light port connection normal light Flash: light port has data communication
Light: light port connection normal light Flash: light port has data communication
Lights: expressed as a rate of 1000M
Flashlight: data transmission
Long press RESET, RUN light Long bright, and then flash, quick. Grow after flashing, open RESET key, wait for RUN
indicatorRestore to factory default when flashing slowly
(1) Login system default lP: 11.11.11.254 User name: root password: admin
Conmect th opicalfiher to the computer through the network cable. Set the lPaddress of the computer to 11.11.11.xxx
and enterthe URL 11.11.11.254 in the browser.
Login screen appears.
账户
(User name)
Click the " OK" button
(3) Pop up the following interface. Select second root nodes of ring network
Select the second"Ring root node"
when the input is complete.
Ring network configuration
root
确定
Please click "OK" button
to complete the last step
确定
环网设置
环网设置
密码
(password) admin
环网根节点
未定义功能
环网根节点
环网从节点
快速生成树
This feature is not defined
Ring root node
Ring network slave node
Rapid spanning tree
11
12
