GVC-72000
8
OPERATION
WARNING:
Always wear gloves, protective glasses and ear protection while
operating this machine.
1.
Turn the main power disconnect
8
(Pic.1) to the ON position, Power ON LED
5.1
(Pic.2) will illuminate.
2.
Open the water supply, and switch the Water Feed switch
4.2.
to the ON
position. The tank will begin to fill; sensors ensure the correct water level. The
internal water tank is refilled automatically and continuously.
CAUTION:
Never switch ON the Water Feed Switch
4.2.
(Pic.1) if the machine is
not connected to a water hose. This would cause water to flow out of the tank and
onto the floor. When done working, turn the Water Feed Switch
4.2.
(Pic.1) OFF and
disconnect the water hose.
3.
Push the boiler ON button
5.5
(Pic.2), the pump will start filling the boiler and
LED
5.3
(Pic.2) lights up.
4.
When the pump stops LED
5.3
(Pic.2) goes out and the heating phase begins,
lasting approximately 5 minutes. During the heating phase, LED
5.4
(Pic.2) will
continue to blink.
5.
When LED
5.4
(Pic.2) stops blinking and stays on, the machine is ready for
use. During use this light will often blink to show that the heating elements are
cycling on.
6.
Insert the hose into the hose connection socket
1, 2 or 9
(Pic.1) (depending on
the application), ensuring that it is securely fitted.
7.
Fasten accessories to lances by firmly pushing them on to the tip (nozzle)
3.3
(Pic.3)
8.
Pull the trigger
3.1
(Pic.3) on the hand-grip to start the steam output and direct
the steam jet towards the area to be cleaned.
9.
Control steam output by selecting the two hose output ‘A-A’ or single hose
output ‘B’ on the steam output selection switch
4.4.
(Pic.1).
10.
With the output power selection switch
4.3.
(Pic.1), change between 36kW and
72kW power output (one hose or both hoses).
NOTE:
When knob
4.3.
(Pic.1) is in the 36kW position, steam will only be released
from position
1
. When knob
4.3.
(Pic.1) is in the 72kW, steam will be released from
both
1 and 2
outputs
OR
the optional hose that connects to port ‘B’,
NOT
both.
NOTE:
Before beginning steam cleaning operations, evacuate the condensation
left inside the steam hose into a bucket or other suitable place.
WARNING:
In case of danger, injury of the operator, leakage of steam or anything
that makes it difficult to regularly turn the machine off, immediately hit the
emergency OFF button 3 (Pic.1). The switch will remain in the off position until
manually reset by turning the switch so that it pops back up! Reset ONLY after
having removed the cause of malfunction. See the troubleshooting section!
Содержание GVC-72000
Страница 13: ...GVC 72000 13 NOTES ...
