GOS-6200 OSCILLOSCOPE
USER MANUAL
⎯
32
⎯
△
T
:
Time difference measurement.
△
T%
:
Time difference percentage measurement.
(5div=100% reference).
1/△
T : Frequency
measurement.
△θ
: Phase
measurement.
(5div=360
o
reference).
OFF
:
During the Cursor measurement going, the function of Auto-measurement
is still working at the same time automatically, and the screen is always
appeared “auto-measurement” at the right down corner. After the Cursor
measurement mode is set off, there are four measurement parameters
available for selection in the sequence as follows:
FREQ—PERIOD—
±
WIDTH—
±
DUTY—OFF
GOS-6200 OSCILLOSCOPE
USER MANUAL
⎯
33
⎯
Input connectors
The input section is where the input signals are commonly connected to
the oscilloscope.
(36)
CH1
—Input BNC socket
This BNC socket is the signal input for channel 1. In X-Y mode,
signals at this input are used for the Y or X deflection. The outer
(ground) connection is galvanically connected to the instrument
ground and consequently to the safety earth contact of the line/mains
plug.
(37)
CH2
—Input BNC socket
This BNC socket is the signal input for channel 2. In X-Y mode,
signals at this input are used for the X or Y deflection. The outer
(ground) connection is galvanically connected to the instrument
ground and consequently to the safety earth contact of the line/mains
plug.
(38)
Ground socket
—Banana Socket galvanically connected to safety
earth.
This socket can be used a reference potential connection for DC and
low frequency signal measurement purposes.
