- 3 -
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 1
Fig. 4
TEST
TEST
RESET
RESET
Use the included screws to attach the mounting clips to the
wooden mounting surface (
Fig. 3
). Use the nylon ties to attach
Flexolight to more permanent structures (
Fig. 4
).
It is much easier to shape and install the rope light into the mounting clips if it has been
plugged into an outlet for a few minutes. The heat from the lamps softens the outer plastic
jacket, and allows more flexibility. Do
NOT
shape the rope light while plugged in; warm the
light first, unplug the light, then shape it to suit your needs.
By unscrewing the end cap and re-attaching the second
Flexolight end to the tail end of the first section. However, you
CANNOT
exceed a total length of 300 feet regardless of how
many section you choose to link
(
Fig. 1
).
Carefully remove all the parts from the packaging, and lay
them out on the floor, or other large smooth work surface. Cut
the shipping cables with wire cutters then completely uncoil
your Flexolight rope light. Be careful not to cut or nick the
Flexolight itself (
Fig. 1
).
Connect the cord to the Flexolight by aligning the cord adaptor
with the light adaptor pushing them together then positioning
the lock collar and twisting to tighten. Make sure the rubber
o-ring stays in place to seal out moisture.
(Fig. 2).
Your Flexolight rope lighting can be be extended beyond the by using the unique linking
feature built into each section of rope lights. If you purchase two lengths of Flexolight rope
lighting, you can attach the second section of rope lights to the first section.
The Flexolight rope light has long lasting miniature bulbs that will last for many years of use.
However, these bulbs are
NOT
replaceable. You should not make any effort to replace bulbs
that have burned out. This may create a hazardous electrical shock condition.
Mounting Instructions
Plug-in/Linking Directions
Bulb Replacement Instructions
1
1
2
2
Fig. 5
Fig. 5
Press the Flexolight into the mounting clip. Do
NOT
attempt to
stake Flexolight on the ground with metal stakes or metal wire.
Do
NOT
place in areas where water collects
(Fig. 5).
5
Fig. 6
Fig. 6
Once your have completed laying out the Flexolight rope
lighting to your liking, you can plug the Flexolight rope light into
the nearest outlet to turn it on. As a reminder, if installed
outdoors, you use a Ground Fault Circuit Interrupting (GFCI)
outlet for safe operation
(Fig. 6).
6
3
4
