17
4.2 Installing
Risk of injury by stumbling and falling
• Place, install and transport product, product ts and accessories
in
a
safe
way.
Injury by cutting
• Do not touch the edges of the rotor.
The rotor is sharp-edged.
1.
Loosen the L-fixing screw (4) from the
stand.
2. Unscrew them counterclockwise.
Fig.
11
a).
3. Remove the washer (5) from the
stand
(3).
4. Place the insert in the base as shown in
Fig.
11
b).
5. Place the stand on the base. Fig. 11 c).
The stand must slide into the specified
recess.
6. Turn stand and base upside down.
The holes in the base and stand must be on
top
of
each
other.
7.
First
place
the
washer
on
the
hole
in
the
base.
8. Insert the L-fixing screw through the washer
and
the
hole
in
the
insert
and
stand.
9. Tighten the L-screw clockwise. Fig. 11 d).
Fig. 11:
Mounting Base
10. Turn the stand base unit upside down
again.
11. Unscrew the 4 Phillips screws (6) from the
engine
block
by
turning
them
counter-
clockwise.
Fig.
12
a)
12. Push the rear protective grille (7) with the
handle
upwards
onto
the
motor
axis
(14).
The eyelets in the protective grille (12) must be
flush with the holes (13) in the engine block.
Fig. 12 a).
13. Insert the 4 Phillips screws through the
eyelets
in
the
protective
grille
and
into
the
holes of the engine block (13)
.
Fig. 12:
Mounting rear part protective grills
14. Tighten the Phillips head screws clockwise
.
