Proprietary Information - Confidential
DO001152
GoBeam-8000
Assembly Instruction
Revision:
1.1
Page: 3 out of
16
Approval Date:
16.12.2013
Effective
Date:
16.12.2013
Update by
:
Approved by:
Oleg Einem
Nimrod Tenne
Sharon Ashkenazi
Page
3
of
16
DO001152 REV 1.1
Printed version are uncontrolled
1. Introduction
This document describes in detail the assembly process of the GoBeam-8000 Top level Systems.
2. Required Tools
Automatic screw drivers with torque (for example “Delvo” DLV-7333 and DLV-7140).
Philips screw head bits size 1 and 2.
Hexagon head bit size 5mm.
PLCC Instructor.
3. General Instructions
3.1.
Before assembling verify that all required items are in following conditions:
3.1.1.
Parts are in correspondence with proper part numbers and revisions.
3.1.2.
All items are in good condition, not damaged and fully clean.
3.1.3.
Each component has relevant certificate, test report and approval.
3.1.4.
Tools are calibrated, tested in time and approved for use.
3.1.5.
Working place is properly equipped, clean and free of extraneous objects.
3.2.
All assembly executors must carefully follow these instructions.
3.3.
Unless otherwise specified use Soudure NET 9418 (Go P/n: MS000010) for cleaning and
degreasing.
3.4.
Unless otherwise specified screws bit size and closing torque should be in accordance with the
following table:
Screw Size
M2
M3
M3 Nylon
M4
M5
Bit size
1
2
Required Torque
4 kg-cm
3.5 lb-In
6.9 kg-cm
6 lb-In
3.5 kg-cm
3 lb-In
17 kg-cm
14.8 lb-In
30 kg-cm
26 lb-In
