GÖLZ FS125, Инструкция по эксплуатации и каталог запасных частей

Страница: 16 / 44

FS125
- 31-
5009002-00
BA-DE-GB-FR-NL (001)
®
Note: Do not lower the cutting disc
forcibly, this could lead to damage to
the cutting disc and to the machine.
The working area is reserved only for the operator.
Keep unauthorized persons out of the working area.
Make sure the operator always has well sight to the
working area. He always has to intervene in the
working process. Never operate the machine without
mounted safety devices.
Careless handling can lead to life-threatening injuries
caused by the rotating cutting disc. Only operate the
machine with fully mounted blade guard.
Nobody is allowed to remain in the working area nor in
the area where falling segments of the cutting disc can
be accelerated outwards (minimum safety distance
10m). If this safety distance cannot be respected, the
danger zone must be closed or be marked by warning
signs.
Care for the whereabouts of cooling and rinsing water
as well as of cutting sludge.
Cutting sludge must be collected, filtered and disposed
of.
4.2 Starting the machine
Completely rise the machine (blade may have no
ground contact). Start the engine as described in the
engines manual.
4.3 Cutting operation
Connect the water supply and slowly lower the
machine with the hand wheel (1) till the blade has
ground contact. Putting down the machine to the
desired cutting depth which is displaying on the cutting
depth indicator (2).
Before you lower the machine by means of the hand
wheel (1), the mini ball valve is to be opened. Lower
the machine to such extent that you reach the desired
cutting depth (2).
Pull then the indexing plunger (3) on the control panel,
so that it snaps into the catch disk in order to fix the
desired cutting depth.
Work with even feed pressure. Too high feed pressure
leads to overload of the engine, there is a risk that the
machine raises. Too low feed pressure polishes the
segments and they become blunt.
4.4 Stop cutting operation
After cutting completely raise the machine and cut off
the engine as described in the engines manual.
4.5 Changing the blade
The blade must be changed if:

the diamond segments of the blade are
completely worn

the material to be cut changes

the blade turns irregularly

the diamond segments are damaged or broken
For fitting a new blade, proceed as described in the
chapter "Mounting the blade".
5. Maintenance
5.1 General
During cuts displace the machine
only with non-rotating blade (not
running engine)!
Danger: Down coming parts at the
building site can cause injuries to the
operator!
Danger: As soon as the combustion
engine is started, the cutting shaft,
respectively the cutting disc, starts
rotating too!
Danger: Some parts of the
combustion engine become very hot
during operation, risk of burns!
Information: Unconditional observe
the owner’s manual of the engine
manufacturer, which is added!
2
1
3
Danger: Operating with too high feed the
machine might rise out of cut! In
emergency situations cut off the engine
as described in the engines manual!
Attention: In order to avoid damage to
the machine and the cutting disc, please
observe the maximum cutting depth!