7
TELEPHONES PROGRAMMING
Set to ON the switch number 2 of the configuration dip switch, that's
accessible by opening the terminal connector protection cover
(see door panel instructions manual).
The door panel will reproduce a sound to advise that the system
has entered into programming mode.
In systems with more than one door panel, the programming process
shall be done on the master door panel only.
rogramming the telephones.
P
Lift the handset while pressing the lock release push button.
To show that the system is ready for programming,
the door panel and handset will reproduce a sound,
being possible to stablish audio communication.
Release the lock release push button.
Press the door panel push button that will
call to this telephone. At this moment
the door panel and handset
will reproduce a sound.
To program the telephone as master,
replace the handset.
To program it as slave, press the lock
release push button.
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed.
Repeat these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a sound to advise
that the system is still into programming mode.
