a. 4 – 5/16-18UNC HH cap screws x 1” Lg.
b. 4 – 5/16 Lock Washers
c. 4 – 5/16-18UNC HH Nuts
2. Mount the 3/8” hydraulic hose to 3/8” JIC adapter located on the lower end
of the Hydraulic splitter. Fill reservoir tank with hydraulic oil (SAE 10
weight non-foaming non-detergent) and plug into 110 volt power source.
3. The lock release cable should already be installed at the lock end of the lift.
Attach the other end of the lock release cable to the brake handle and mount
to the power unit stand handle.
Work Platform Assembly Instructions:
1. Raise scissor lift to its maximum height and remove the 4 swing arms if they
are mounted to the slots on the lift. Load work platform with approach ramp
hinge pipe on the opposite end of the cylinders and safety latch. Center
platform from side to side and attach using the spacer bolts P/N: PMR-6550
and ½” USS flat washers P/N: PMR-6158 to secure the work platform to the
scissor lift. Before tightening, slide the table as far back to the approach ramp
end as possible and tighten mounting bolts, DO NOT OVER TIGHTEN
BOLTS.
2. Install the 4 set screws into the 4 corners of the recessed surface plate cutout
and set the machined Surface Plate into the table top using the T handles
provided. The set screws will allow you to level the surface plate if desired.
3. Next, bolt the push rod assembly underneath the work platform with the ¼-
20UNC bolt, ¼” flat washer, ¼” lock washer and ¼-20UNC nut as shown in.
Slide push rod assembly to the very back of the slotted holes.
4. Next is to pin the ramp to the work platform using the ramp pins P/N: PMR-
6608. Attach pins from inside and slide toward outside.
5. Lower lift slowly to make sure the push rod is working properly. If ramp is
not sliding smooth as the lift goes down, raise the lift, loosen the spacer bolt
and slide the work platform at ½” increments as required.
6. Place side and front rails on work platform as shown in Fig. #1.
Lift Specifications:
Lowered
Height 3
7/8”
Current 110V
Raised
Height
48”
Motor
Output
1
HP
4
