All contents copyright 2015, GOLDWING RC Version 2.0, May 2015
3.4
Cut the covering from the aileron servo slots from corner to corner and iron down inside
the openings. Connect servo wire extensions to your servos and secure the connections with
the supplied clips. Feed the servo wires into the wing and out the root. The screw holes for
servo mounting are laser pre-drilled, it is advisable to apply some thin CA to strengthen them,
Install the servos and screw firmly in place.
3.5
Use your radio to set the centers of each servo and then assemble and adjust the
length of each control rod, KUZA 1” aluminium CNC servo arm is recommended for aileron
control (sold separately). The servo arm should be as close to perpendicular to the control rod
as possible while the aileron is at neutral. Double check all screws, bolts and nuts to assure
proper installation and operation without binding.Once satisfied, permanently attach the ball
links to the servo arms and horns with the supplied screw and nut.
3.6
Check the final radio operation of the ailerons and make sure there is no binding or
servo fighting of each other. Also check to make sure all linkage bolts and nuts are secure.
