Installation
Installation
Installation
Installation
Installation
Direct mounting on control
1.
Disconnect power from SP control
2.
Remove the setpoint access panel from the
control cover.
3.
Feed TD-30 cable through the cover and
plug into the phone jack type connector on
the SP control (located to the left of the
setpoint adjustment knob).
4
Tuck the TD-30 cable by folding it and
pushing the slack down into the control,
making sure not to block the back of the
setpoint access hole.
5.
Now snap the TD-30 into the front panel of
the control.
6.
Restore power and check operation of the
control. The setpoint can be adjusted using
the 1/8" Allen wrench through the access
hole in the TD-30.
Panel Mounting
1.
Cut a 3.94" x 1.5" (3 15/16" x 1 1/2")
rectangular opening in the panel. Panel
thicknesses from .030" to .190" (3/16") are
suitable.
2.
Connect an extension cable between the
TD-30 and the SP-30/30D/300. Refer to
"TD-30 extension cables" section for more
information.
Wall mounting
1.
The MK-1 wallplate allows the TD-30 to be
flush mounted on a wall over a 3 gang
electrical box. Alternatively, the MK-2
bracket allows the TD-30 to be mounted
onto a wall without penetrating the wall
surface.
Both the MK-1 and MK-2 mounting plates
must be ordered separately and are avail-
able at your Goldline dealer
2.
Connect an extension cable between the
TD-30 and the SP-30/30D/300. Refer to
"TD-30 extension cables" section for more
information.
TD-30 Extension Cables
Two types of extension cables can be used to
mount the TD-30 remote from the control:
Male/Female type: This phone cable has one male
jack and one female jack. Plug the TD-30's short
cable into the female jack and plug the male jack
into the SP-30/30D/300 control.
Male/Male type: This phone cable has two male
jacks. Remove the short cable from the TD-30 by
reaching into the small access hole in the rear of
the display, depressing the jack tab, and gently
pulling. Plug one male end into the TD-30 and the
other into the SP-30/30D/300 control.
Custom Length: A male/male extension cable can
be assembled by following the diagram below.
Connectors, cable and assembly tools can com-
monly be found at electrical supply outlets. Note
that each conductor's position on one jack, differs
from the other. Wire accordingly.
2
2
3
3
4
4
5
5
B L K
R E D
G R N
Y E L
T D -30 C u sto m E xtension C able
T
D
3
0
B
.CDR
4 w ire flat phon e cab le
5 00 ft
m axim u m
R J -11
C o n ne ctor
R J -11
C o n ne ctor
Page 2
