Goldline AquaRite Long Life, Руководство пользователя

Страница: 13 / 27

6
Controls
Main Switch
AUTO : For normal operation, the Main Switch should be left in the AUTO position. In this
position the AquaRite Long Life Electrolytic Chlorine Generator will produce chlorine
according to
the "Desired Output %" adjustment setting for the entire filtering/pumping cycle.
SUPER CHLORINATE : When you have an abnormally high bather load, a large amount of rain,
a cloudy water condition, or any other condition which needs a large amount of purification to be
introduced, put the Main Switch in the SUPER CHLORINATE position. This electronically
“super chlorinates” (shocks) the water for 24 hours (filter pump must be on during this time) or
until the power has been turned off, whichever comes first. At the end of the super chlorinate
time, be sure to put the switch back into the AUTO position.
OFF : The OFF position prevents the AquaRite Long Life Electrolytic Chlorine Generator
from energizing the AquaRite Long Life Electrolytic Chlorine Generator cell. In this position
there is no chlorine generation. NOTE: To service any of the pool equipment or the AquaRite
Long Life Electrolytic Chlorine Generator , turn the power off at the circuit breaker.
Indicator LED's
POWER When illuminated, the AquaRite Long Life Electrolytic Chlorine Generator has input
power.
GENERATING This LED is on steady during normal operation. When flashing, the pool water is
too hot or cold to operate.
SUPER CHLORINATE Illuminates during super-chlorination. See description above.
REMOTELY CONTROLLED When illuminated, indicates that a remote pool automation
control (Goldline Aqua Logic, Pentair Intellitouch, Polaris Eos, etc.) is controlling the AquaRite
Long Life Electrolytic Chlorine Generator --the main switch and "Desired Output %" adjustment
are inactive. When flashing, the Aqua Logic, Intellitouch or Eos is in SERVICE or TIME-OUT
mode and the Main Switch and "Desired Output %" adjustment are active.
NO FLOW When illuminated, the flow switch has detected no water flowing and the AquaRite
Long Life Electrolytic Chlorine Generator has stopped generating chlorine. A flashing LED
indicates a
15-60 second time delay period.
CHECK SALT When flashing, the salt level is low (below 2700 ppm) and AquaRite Long Life
Electrolytic Chlorine Generator is generating at low efficiency. When illuminated steady, the salt
level is too low and AquaRite Long Life Electrolytic Chlorine Generator has shut down. Before
adding large quantities of salt, it is advisable to have your salt level professionally checked.
HIGH SALT When illuminated, the salt level is too high and AquaRite Long Life Electrolytic
Chlorine Generator has shut down.
INSPECT CELL A flashing indicator signifies that either the AquaRite Long Life Electrolytic
Chlorine Generator Cell efficiency is reduced or that it is time for regularly scheduled cell
inspection. In either case, inspect the AquaRite Long Life Electrolytic Chlorine Generator cell
and clean if necessary. When illuminated steady, AquaRite Long Life Electrolytic Chlorine
Generator cell efficiency is greatly reduced and the AquaRite Long Life Electrolytic Chlorine