Golden wheel CS-471, Инструкция по эксплуатации

Страница: 5 / 14

10] HOW TO INSTALL THE BOBBIN
1. After pulling out thread approximately 10 cm
from bobbin ① , put the bobbin into bobbin case
②.
2. Pass the thread through the threading groove Ⅰ
in the bobbib case.
CAUTION:
Fit the bobbin in the bobbin case so
that the bobbin turns in the direction
of the arrow when the bobbin thread
is pulled.
3. Pass the thread through thread slit Ⅱ and pull
it up. Then the thread can be passed under the
thread tension spring ③ and pulled out.
4. Push the bobbin case into the original position
of holding the bobbin.
11] HOW TO THREAD THE MACHINE HEAD
1. Turn the handwheel by hand to move the
thread take-up lever to its top position.
2. Thread in the order illustrated and thread the
needle from the left to the right.
3. Pull out the thread, which has been threaded
in the needle, approximately 10 cm.
CAUTION:
Thread the right-hand side of sec-
tion ⑧ when viewed from the face
plate.
12] ADJUSTING THE STITCH LENGTH AND
REVERSE STITCHING
◆ Adjusting the stitch length
To adjusting the stitch length, use the feed
regulator nut ① .
Align the upper end Ⅰ of the feed lever to the
scale indicating the desired amount.
To increase the pitch, turn the nut counter
-clockwise.
To decrease the pitch, turn the nut clock-
wise.
( To decrease the stitch length, turn the nut
while slightly pushing the feed lever down. )
◆ Reverse stitching
To carry out reverse stitching, push the feed
lever up by hand as far as it will go.
Reverse stitching can be done only when the
feed lever is pushed up.
③
Ⅱ
Ⅰ
①
②
③
⑦
⑤
④
⑥
⑧
⑨
⑩
①
②
①
Ⅰ
- 5 -