GOLDEN TANDOORS
Step 1 : IGNITION OF PILOT
GT-610AG & GT-710AG Tandoor Oven Installation & Operation Manual
Operation Procedure
The Tandoor Gas Circuit (Schematic Diagram GC-01) is equipped with
a flame failure safety circuit that includes an initial pilot of lighting
the main burner.
Press the knob downwards (keep depressed) and rotate
anticlockwise till a 30 degree turn (you will feel a mechanical stop).
While the knob is still depressed fire the igniter (a couple of times).
This shall ignite the pilot flame (diagram P-01).
Keep the knob depressed for 10 to 15 seconds.
The first ignition will require the installer to purge air from the lines
and may take a couple of attempts before burner remains light.
IGNITER
MAIN VALVE KNOB
PANEL ENLARGED VIEW
VALVE KNOB ROTATION
ENLARGED VIEW
PILOT THERMOCOUPLE
IGNITER ASSEMBLY
GT-610710AG-2016V1-E
Diagrams Not To Scale
POINTS TO NOTE
1. Gas is only being delivered to the pilot in the first step.
2. The gas is not being delivered to the main burner.
3. After about 15 seconds the thermocouple will heat up for further
transfer of gas to the main burner.
4. Pilot/burner ignition will be confirmed by sight by opening the
viewing panel on the front of the control box.
Step 2 : IGNITION OF THE MAIN BURNER
Once the pilot is ignited and the thermocouple has taken heat you
can release the depressed knob to turn it further anticlockwise to
LOW. This shall be the slowest position of the burner where the
burner should be ignited.
The burner shall cross light and then you can turn the knob
clockwise to HIGH for maximum flame.
POINTS TO NOTE
1. The pilot and the burner both shall run now.
2. The main valve has a simmer control (LOW) at the end of the turn.
3. Unless required heat the tandoor at low flame and then increase
when desired.
4. Never keep your face on top of the main tandoor hole when
igniting the main burner. A lot of heat is emitted when the main
burners work.
THE TANDOOR IS NOW OPERATIONAL AND ONCE HEATED TO THE DEGREE
REQUIRED AS PER THE NEED OF THE CHEF COOKING CAN BEGIN.
IMPORTANT! DO NOT FORGET TO SLOW HEAT THE TANDOOR FOR THE FIRST
TIME YOU OPEN THE PACKAGE.
THE SLOW HEATING IS ONLY REQUIRED ONCE TO A NEW TANDOOR.
8
Diagram P-01
LOW
HIGH
SPARK
OFF
