Golden Motor Magic Pie 4, Руководство пользователя

Страница: 17 / 21

13
13 13
13
MAGIC
MAGIC MAGIC
MAGIC PIE
PIE PIE
PIE 4
4 4
4 KIT
KIT KIT
KIT /SMART
/SMART /SMART
/SMART PIE
PIE PIE
PIE 4
4 4
4 KIT
KIT KIT
KIT
User’s Guide
8.2
8.2
8.2 8.2 Motor hall-sensor malfunctions
When the controller detects a motor hall-sensor failure, it will beep twice before automatically
entering into sensor-independent control mode. Twist/press the throttle to run the motor and pedal
your bike for a push start if the motor does not operate. (This malfunction seldom happens in a state
of sensor-independent control status)
8.3
8.3
8.3 8.3 Throttle malfunctions
When the throttle fails to function correctly, the controller will beep three times. In this
situation, press and hold the cruise control button to drive your bike at half the maximum speed.
The controller will automatically return to its original status when the problem is resolved.
8.4
8.4
8.4 8.4 Power-brake lever malfunction
If the power-brakes level malfunctions ( i.e. disconnected from the controller), twist/press the
throttle repeatedly for at least four times. The controller will then beep four times if this malfunction
is detected. Similarly, press and hold the cruise control button to drive your bike at half the maximum
speed. The controller will automatically return to its original status when the problem is resolved.
8.5
8.5
8.5 8.5 Riding feels wobbly and unstable
�
Check that wheels are centered.
� Check the bearing play of the hubs by lifting the bicycle and spinning the wheel.
�
Check the play of the hubs while trying to move the rim from side to side between the forks.
� Verify spoke tightness and rim alignment.
�
Inspect and tighten screws and nuts on the handlebar and stem
� Tighten the saddle clamp as needed
Check spoke tension regularly. Approximately the same tension should be applied to all spokes.
Tighten loose spokes at the nipples using a spoke wrench. If you detect a loose spoke or if the rim has
a side play of more than 4mm (1/8 inch), have the wheel trued by a bicycle mechanic.
8.6
8.6 8.6
8.6 Light(s) not working
�
Check that the wiring is not broken.
� Check that the bulbs are inserted correctly.
�
Check that all connections are made properly and secure.
8.7 8.7 8.7 8.7 Unknown malfunctions
If your e-Bike fails to move and the cause is unknown or if your battery is low, you can force your
eBike to work. While squeezing the power-brakes, press the cruise control button five times and if you
hear the honk from your horn, press and hold the cruise control button again and you can drive your
bike at half speed. You will need to turn off the battery power to reset the controller back to normal
mode after the problem is resolved.