GOLDEN MASK Deep Hunter Mobile, Инструкция по эксплуатации

Страница: 6 / 12

GM Electronics Ltd
.
Golden Mask Deep Hunter Mobile ST
– Instruction manual
6
battery; there are 3 embedded LEDs for indicating the type of the metal
and the condition of the battery:
"Fe", "n-Fe" - LED indication of the type of metal - green for
ferrous metals and red for non-ferrous metals;
"Battery!" is a LED for indicating less than 10% residual charge
of the built-in battery, indicating a necessary recharge (see #9 );
The
battery check function is set to run automatically each time the
detector is turned on. For a few seconds, the arrow on the meter shows
the battery status. If this reading is in the green sector of the scale - the
battery has enough charge and the detector can be used. When the
arrow shows values close to the red sector and/or the LED
"Battery"
lights up red - the battery must be charged. (see #9)
4.Ground Balance.
The Golden Mask Deep Hunter Mobile ST provides full range
automatic ground balance based on a special
“Flash Auto Ground
Balance
”
system which is a standard to all pulse detectors Golden
Mask . It does not need any settings and continuously rejects the signals
generated by changing soil conditions encountered while searching.
In high mineralized soils the noises have to be reduced additionally by
the
“REJECT”
control knob or by reducing the
“GAIN”
control of the
detector.
5.Search for metal objects.
The search for metal objects with the Deep Hunter Mobile ST consists
of slowly moving the search antenna above the ground. It is important
to know that this detector achieves the best results when the antenna is
kept at a constant height of
10 ÷12 cm
from the ground. If you hold the
coil too low or touch the ground, you will experience faulty signals.
Unlike traditional
VLF metal detectors , using the principle of inductive
balance and some pulse detectors designed for gold prospecting
mainly, the
Golden Mask Deep Hunter Mobile ST can detect metallic
objects without motion. It is
“no motion”
machine. The movement is
only necessary to identify the type of metal, a speed of about one m/s
is sufficient for the discrimination system to function properly.