4
Operating Instructions
Visually inspect the Dynamic Personal Heater for any damages before operation. Do not
operate the heater if any damages are detected. Contact your dealer immediately.
1) Plug the power cord directly into a standard/conventional 120V/15 AMP receptacle.
Notice that you have two power settings on the power switch located on the front of the
Dynamic Personal Heater. The top of the power switch has one bar indicating the LOW
setting. The bottom of the power switch has two bars indicating the HIGH setting. If you
want to activate the LOW setting, press on the one bar at the top of the power switch. If
you want to activate the HIGH setting, press on the two bars at the bottom of the power
switch. (see Figure 1) Regardless of your choosing the LOW or HIGH setting, the red
light above the power switch will activate after the power switch is pressed. (see Figure 2)
Figure 1
Figure 2
