M
M
M
MO
O
O
OD
D
D
DE
E
E
ELL
L
L X
X
X
X D
D
D
DIIIIG
G
G
GIIIIT
T
T
TA
A
A
ALL
L
L T
T
T
TR
R
R
RA
A
A
AN
N
N
NSSS
SM
M
M
MIIIIT
T
T
TT
T
T
TE
E
E
ER
R
R
R C
C
C
CA
A
A
ASSS
SE
E
E
E
Activating the Transmitter
Before turning on the transmitter the user should make sure that it is set up
for the locating job he intends to perform For example if the user intends to
energize a line by direct connection he should plug the DCC into the
SIGNAL[ ] or SIGNAL[ ] jack and connect the red clip to the hook up point
and the black clip to ground
When either SIGNAL jack is being used the word “DIRECT” will be indicated
at the top of the display screen When neither jack is being used the word
“INDUCTIVE” will appear at the top of the display If the user wishes to use
the INDUCTIVE feature to energize a line he should make sure both SIGNAL
jacks are empty
Once the transmitter is set up activate it by pressing and holding the
button until the display flashes the word “On” Then release the button
After “On” flashes the current firmware version is displayed (e g “
”)
Then the transmitter will completely activate displaying the active
operating frequency
Selecting a Locating Frequency
To select an operating frequency the transmitter must be in frequency
adjustment mode This mode is selected if either “Hz” or “KHz” is displayed
on the right half of the display screen
If frequency mode is not selected use the Select button
to advance to this
mode
Use the
or
button to select a
higher or lower frequency respectively
To the right is a typical screen one
would see while adjusting the
frequency
Setting Output Level
To set the output power level the transmitter must be in power level
adjustment mode This mode is selected if the “ OUTPUT” label is displayed
in the lower right corner of the screen If this mode is not selected use the
Select button to advance to it Then
use the Up or Down button to select a
higher or lower output level The
available output levels are:
and
To the left is a typical
screen one would see while adjusting
the output level
