background image

Overview of Goldair Electric Throw 

9 HEAT CONTROL 

 

The control features an on/off switch and two buttons to control the heat settings and the timer.  
It also has an LED readout for temperature and timer settings. 

Your Goldair Electric Throw is equipped with a 9 heat control.  

OPERATING INSTRUCTIONS 

1.  You  can  program  your  Throw  to  work  for  1-9  & 
12 hours and 1-9 heat settings 

2.  Plug  into  the mains  power  supply  and  switch  on 
the power mains  

3. Switch on the Throw with 

On/Off

 button.  

4. The LED for timer and temp will be illuminated.  

5.  By  pressing  the  Temp  button  you  will  be  able  to 
adjust  the  heat  settings  from  1

–9.  1  being  lowest 

and 9  being highest. This will be indicated  with the 
left LED. 

6.  You  can  also  set  the  timer  to  turn  the  Throw  off 
after  a  predetermined  time  being  1-9  hour  or  12 
hours. The LED will show 

“H” when the timer is set 

to  12  hours.  This  will  be  indicated  with  the  right 
LED. 

LED Readout 

Timer Button 

On/Off Switch 

BEFORE FIRST USE 

Before using your Electric Throw for the first time; 

The Throw needs to be unfolded and laid flat before 
switching on. 

we  recommend  that  you  switch  your  Throw  to  the 
maximum  setting  for  two  to  three  hours  before 
bedtime  then  reduce  to  your  desired  heat  setting 
when sleeping. 

 

EVERYDAY USE 

With normal use your Electric Throw will require  15 
minutes  of  preheating  on  the  maximum  setting 
before  bedtime.  We  recommend  that  you  turn  the 
Throw down to Low or off when sleeping. 

STORING YOUR THROW 

Always  allow  the  Throw  to  cool  before  storing. 
Remove  the  control  and  roll  or  fold  the  Throw 
loosely  and  store  it  in  a  bag  or  the  bag  it  was 
supplied  in.  Avoid  pressing  sharp  creases  into  the 
Throw. 

Temperature  
Button 

Содержание GEFT200






Отзывы: