WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke.
This odour or smoke is a normal occurrence
caused by the initial heating of the internal
heating elements and should not occur again.
OPERATION
Check that the Power Switch at the back of the
heater is set to the Off position before plugging
the heater in and turning on the mains supply.
Turn the Power Switch at the back of the heater
to the
“I” position. You will hear a beep.
Press the Power button on the control panel to
turn the heater on. The LED will display the
current room temperature and begin to blow out
air on Low Heat mode.
To turn the unit off, press the Power Button on
the control panel and then turn the Power Switch
at the back of the heater to
“O” position.
Please note: the fan will continue to run even
though the elements have switched off. This is
normal.
THERMOSTAT
Press the arrow up or arrow down buttons to
adjust the temperature to your desired setting
(from 15-35°C). Once you have set the desired
temperature, the LED will display the room
temperature again and will rise as the room
temperature increases.
Once the heater reaches the set temperature it
will cycle on and off to maintain the set
temperature.
MODE
Press Mode button once for High heat, twice for
Fan Only and a third time to go back to Low
Heat.
For greater economy, use the High Heat setting
initially and then switch to the Low Heat setting.
For the Low and High Heat settings the fan
remains at the same speed; only the element
changes to create the greater/lesser heat output.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the unit
before use. This appliance requires no installation, it should be used solely as
a portable appliance.
OSCILLATION
The
“OSC” button turns the heater oscillation
function on and off.
TIMER
The timer function allows you to set the length of
operation time before the unit shuts Off.
When the heater is On, press the Timer button.
The timer icon will display on the control panel
and the amount of time remaining before the unit
switches Off will be displayed.
Set the amount of time before shutdown by
pressing the Timer button one or more times. The
set time will increase by one hour increments to a
maximum of 9 hours.
The control panel will return to display the current
mode setting and the symbol to indicate you have
set the timer will display on the screen. When the
programmed time as been reached the heater will
turn off.
To cancel the timer, increase the set time to 9
hours and then press the Timer button again. The
timer symbol will disappear from the screen.
REMOTE CONTROL
The remote control buttons perform the same
functions as those on the control panel of the unit.
For best results, aim the remote directly at the
remote sensor on the front panel of the heater.
The remote has a 3 metre range of operation.
The remote control requires two
“AA" type battery
(not included).
IMPORTANT! NEVER COVER THIS HEATER!
CAUTION: The Heater generates heat during
use. Proper precautions must be taken to
prevent the risk of burns, scalds, fires or other
damage to persons.
Do not use this heater with a programmer,
remote-control system, separate timer or any
other device that switches the heater on
automatically.
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service
technician.
Operating your Ceramic Tower Heater
