1. Ensure that the cap on the Water
drainage outlet of the unit is tight. Pour
clean cold water into the water filler area,
observing the water level indicator in the
bottom front panel.
CAUTION: DO NOT SPILL OR ALLOW
WATER TO COME IN CONTACT WITH
THE CONTROL PANEL
Do not overfill past the MAX water indicator
mark. If desired, place ice in the ice tank in
the top of the unit.
Do not pour water into the ice tank.
Do not allow the combined use of water and
ice to overfill the water reservoir.
When moving the unit, do so with extreme
caution, so as not to spill any water in the
reservoir. The unit should be moved slowly
and in a sideways direction.
Always keep the unit upright.
2. Connect the unit to a power outlet of the
same voltage and frequency as indicated on
the rating plate. The unit ON/OFF LED for
the power will light to indicate that there is
power to the unit.
3. Turn the unit ON by depressing the
ON/OFF button. The unit will start and then
revert to the initial Normal/LOW speed
setting. Further operation can be performed
by pressing the SPEED, MODE, TIMER,
COOL and SWING buttons.
4. If you wish to turn the unit off at a pre-
determined time depress the TIMER button.
The unit can be set to turn off at any time
between 0.5 hour and 7.5 hours from
“Turn
On” by depressing the TIMER button. If no
time is selected, the unit will operate
continuously.
The time set can be incremented in 0.5hr
steps and the selected time is indicated by a
combination of indicator lights.
Eg. 5.5hrs is indicated by the 4hr LED, the
1hr LED and the 0.5hr LED being
illuminated.
5. To initiate the cooling function depress
the COOL button. It will take a few minutes
for the air to cool.
NOTE: If this button is not depressed the
unit will only circulate
“room temperature”
air.
6. Move the horizontal louver for the air
outlet to blow up or down to suit.
7. The vertical louvres can be set to a
direction or allowed to rotate through 120
o
by depressing the SWING button.
8. All the functions can be performed with
the remote control supplied with this unit.
a) Point the remote towards the unit and
depress the appropriate button. The remote
control will operate up to 4 metres from the
unit.
b) Remove battery cover and install two
“AAA” batteries (not included) as indicated.
(Please observe correct battery polarity.)
9. Depress the OFF button to cancel all
functions.
10. When not in use disconnect the unit
from the power outlet and drain all water
from the water reservoir. (See HOW TO
CLEAN)
NOTE: Initial setting is
“normal” mode and
“low” speed and will occur every time the
plug into plugged into the power main. Once
the cooler has been set to desire function/s,
the cooler will keep memory of the setting
as long as there is power to the cooler (step
2) when it is switched OFF, and without
unplugging the plug from the power main.
Operating your Fan