Goldair GBQMT6, Руководство по эксплуатации

Страница: 32 / 34

Problem Possible Cause Check Procedure Prevention/Solution
No sparks appear at
any electrodes when
ignition button is
pushed; no noise can
be heard from spark
module. Not installed properly. Check battery orientation Install battery (make sure
that “+” and “-”
connectors are oriented
correctly, with “+” end up
and “-” end down.
Dead battery Has battery been used
previously? Replace battery with new
AA-size alkaline battery.
Button assembly not
installed properly. Check to ensure threads
are properly engaged.
Button should travel up
and down without
binding. Unscrew button cap
assembly and reinstall,
making sure threads are
aligned and engaged
fully.
Faulty spark module.
If no sparks are
generated with new
battery and good wire
connections, module is
faulty. Replace spark module
assembly.
No sparks appear at
any electrodes when
ignition switch is
pushed; noise can be
heard from spark
module. Output lead connections
not completed. Are output connections
on and tight? Remove and reconnect
all output connections at
module and electrodes.
Sparks are present
but not at all
electrodes and/or not
at full strength. Output lead connections
not complete. Are output connections
on and tight? Remove and reconnect
all output connections at
module and electrodes.
Arcing to grill away from
burner(s) If possible, observe grill
in dark location. Operate
ignition system and look
for arcing between output
wires and grill flames. If sparks are observed
other than from burner(s),
wire insulation maybe
damaged. Replace wires.
Weak battery All sparks present but
weak or at slow rate. Replace battery with a
new AA-size alkaline
battery.
Electrodes are wet Has moisture
accumulated on
electrode and/or in
burner ports? Use paper towel to
remove moisture.
Electrodes cracked or
broken “sparks at crack” Inspect electrodes for
cracks. Replace cracked or
broken electrodes.
Troubleshooting-Electronic Ignition
Page 31