FIXING THE WALL-MOUNTED BRACKET
•
Measure the distance between the holes situated at the back of the bracket and drill
two holes in the wall at the same distance.
•
Put a plug in the holes and screw the screws in the holes by letting them more or
less 4 millimetres out of the wall.
•
Fix the bracket by putting the screws into the widest part of the holes situated at the
back of the bracket and slide the bracket downwards.
INSTRUCTIONS FOR USE
Charging
•
The vacuum cleaner is powered by rechargeable batteries.
•
Plug in the hand vacuum into the charging base via the jack that is situated at the
rear of the handle to charge. When the unit is being charged, the charging indicator
is on (which is shown by a red light). Once fully charged just take out the unit for
use anywhere.
•
After use, recharge the unit as instructed above. For safety purposes only use the
charger supplied by the manufacturer.
•
Before use, please charge the vacuum for at least 16 hours.
General Use
•
Switch the unit on and off by pressing the on/off switch.
•
Press the nozzle release button, then take out the nozzle. There is a sponge inside
the filter bracket.
•
For a better vacuuming results, always start with a clean filter.
MAINTENANCE
Cleaning Dust Filter and Dust Container
•
Detach the dust container from the motor unit by pressing down the release button
on the bottom of nozzle (above the dust container).
•
Empty the dust container.
•
To clean the filter empty the dust and other debris then wash the filter in lukewarm
soapy water. After washing, rinse until the water runs clear and air dry completely
before re-inserting it in position.
•
Never use the vacuum without the filter in position
.
•
Damaged or worn filters should be replaced for maximum efficiency.
