Gold Medal Shavatron 1020, Инструкция по эксплуатации

Страница: 7 / 16

Shavatron Ice Shaver
Motor Lubrication
The drive motor bearings are sealed and require no lubrication. Do not oil the motor, it will
cause more harm than good.
Changing Fluorescent Lights
Remove the sign retaining angle from the top of the dome, by removing the four screws that
hold it into place, and then slide the sign out to access the light tube. Replace the light tube
and then reassemble in reverse order.
Changing Belts
Unplug your machine. (On units manufactured before 3-1-95.) Raise the hopper lid until the lug
on the right hand side can be lifted out of its slot in the hinge bracket. Slide the lug on the left
hand side out of the hinge bracket, and remove the hopper lid. Remove the two bolts which
hold the hinge bracket to the machine. The dome can now be removed. (On units
manufactured after 3-1-95). Remove the four dome hold down screws. Loosen the four motor
hold down bolts and slide the motor toward the center of the hopper, loosening the belt.
Remove the old belt and install a new one.
NEVER STRETCH THE BELT WHEN INSTALLING THE PULLEY.
ALWAYS LOOSEN THE HOLD DOWN BOLTS. After the new belt is
installed, move the motor to the left by hand as far as possible, making
sure the belt is tight. Re-tighten the motor hold down bolts. NEVER
USE A PRY BAR OR BOARD TO MOVE THE MOTOR.
Lubrication Of Thrust Bearing and Adjustment Of End Play
The small thrust bearing should be lubricated approximately once per season. Unplug your
machine. Remove the dome. To do this, remove the two screws which hold the bracket in
place, and carefully lay the bracket face down on the top frame. A large hex adjustment nut is
located below the pulley on the shaver shaft. Loosen the set screw in the side of the hex nut.
Loosen the adjustment nut as much as possible, so it is up against the pulley.
NOTE: This
nut is of the airplane locking type, therefore, it will turn hard on its threads at all times. By
grasping the pulley, hold the shaft upward as much as you can, and press some grease into
the thrust bearing located below the adjustment nut. Use any variety of sticky type grease,
such as water pump grease or Alpha Molykote Corp., No. 505 “Whitekote” lubricant
(recommended by the bearing manufacturer). After the grease has been applied, screw the
adjusting nut downwards until all play up and down is removed. Do not tighten any further.
Now tighten the set screw and reassemble your machine.
Removal and Replacement Of Glass
To remove glass from the frame, grip the retaining vinyl with needle nose pliers at a corner
and pull. Repeat for each corner of glass. With the vinyl remove the glass will come out
easily. To install new glass, place the glass in the frame, making sure the glass does not enter
the channel intended for the vinyl. Starting at a corner, install the vinyl into the channel (make
sure it locks into place). A knife handle with a rounded point is useful in pushing the vinyl into
position. Obtain Tempered glass from a local hardware store, in the following sizes:
Front Glass (1 required) — 20" x 24" x
1
/
8
"
Side Glass (2 required) — 16" x 20" x
1
/
8
"